PCI: Correct misspelled words
Subsystems (6)
PATCH 1/1 PCI: Correct misspelled words
Fix a number misspelled words, and while at it, correct two phrases used to indicate a status of an operation where words used have been cleverly truncated and thus always trigger a spellchecking error while performing a static code analysis over the PCI tree.
Signed-off-by Krzysztof Wilczyński <[email protected]>
--- drivers/pci/controller/cadence/pcie-cadence.h | 2 +- drivers/pci/controller/pcie-mediatek-gen3.c | 2 +- drivers/pci/endpoint/functions/pci-epf-ntb.c | 2 +- drivers/pci/of.c | 2 +- drivers/pci/quirks.c | 4 ++-- 5 files changed, 6 insertions(+), 6 deletions(-)
drivers/pci/controller/cadence/pcie-cadence.h +1 -1
@@ -310,7 +310,7 @@ struct cdns_pcie {* single function at a time * @vendor_id: PCI vendor ID * @device_id: PCI device ID -* @avail_ib_bar: Satus of RP_BAR0, RP_BAR1 and RP_NO_BAR if it's free or +* @avail_ib_bar: Status of RP_BAR0, RP_BAR1 and RP_NO_BAR if it's free or * available * @quirk_retrain_flag: Retrain link as quirk for PCIe Gen2 * @quirk_detect_quiet_flag: LTSSM Detect Quiet min delay set as quirk
drivers/pci/controller/pcie-mediatek-gen3.c +1 -1
@@ -303,7 +303,7 @@ static int mtk_pcie_startup_port(struct mtk_pcie_port *port)writel_relaxed (val, port->base +PCIE_RST_CTRL_REG );/* -* Described in PCIe CEM specification setctions 2.2 (PERST# Signal) +* Described in PCIe CEM specification sections 2.2 (PERST# Signal) * and 2.2.1 (Initial Power-Up (G3 to S0)). * The deassertion of PERST# should be delayed 100ms (TPVPERL) * for the power and clock to become stable.
drivers/pci/endpoint/functions/pci-epf-ntb.c +1 -1
@@ -1262,7 +1262,7 @@ static void epf_ntb_db_mw_bar_cleanup(struct epf_ntb *ntb, }/** -* epf_ntb_configure_interrupt() - Configure MSI/MSI-X capaiblity +* epf_ntb_configure_interrupt() - Configure MSI/MSI-X capability * @ntb: NTB device that facilitates communication between HOST1 and HOST2 * @type: PRIMARY interface or SECONDARY interface *
drivers/pci/of.c +1 -1
@@ -247,7 +247,7 @@ void of_pci_check_probe_only(void)else pci_clear_flags (PCI_PROBE_ONLY ); -pr_info ("PROBE_ONLY %sabled\n" , val ?"en" :"dis" ); +pr_info ("PROBE_ONLY %s\n" , val ?"enabled" :"disabled" ); }EXPORT_SYMBOL_GPL (of_pci_check_probe_only);
drivers/pci/quirks.c +2 -2
@@ -980,8 +980,8 @@ static void quirk_via_ioapic(struct pci_dev *dev)else tmp =0x1f ;/* all known bits (4-0) routed to external APIC */ -pci_info (dev,"%sbling VIA external APIC routing\n" , - tmp ==0 ?"Disa" :"Ena" ); +pci_info (dev,"%s VIA external APIC routing\n" , + tmp ==0 ?"Disabling" :"Enabling" );/* Offset 0x58: External APIC IRQ output control */ pci_write_config_byte (dev,0x58 , tmp);
Signature · 1 line
2.34.1
Bjorn Helgaas
AppliedQuoted 6 lines · Krzysztof Wilczyński
Fix a number misspelled words, and while at it, correct two phrases used to indicate a status of an operation where words used have been cleverly truncated and thus always trigger a spellchecking error while performing a static code analysis over the PCI tree.
Signed-off-by Krzysztof Wilczyński <[email protected]>
Applied to pci/misc, thanks!
Quoted 78 lines
--- drivers/pci/controller/cadence/pcie-cadence.h | 2 +- drivers/pci/controller/pcie-mediatek-gen3.c | 2 +- drivers/pci/endpoint/functions/pci-epf-ntb.c | 2 +- drivers/pci/of.c | 2 +- drivers/pci/quirks.c | 4 ++-- 5 files changed, 6 insertions(+), 6 deletions(-)drivers/pci/controller/cadence/pcie-cadence.h +1
-1@@ -310,7 +310,7 @@ struct cdns_pcie {* single function at a time * @vendor_id: PCI vendor ID * @device_id: PCI device ID -* @avail_ib_bar: Satus of RP_BAR0, RP_BAR1 and RP_NO_BAR if it's free or +* @avail_ib_bar: Status of RP_BAR0, RP_BAR1 and RP_NO_BAR if it's free or * available * @quirk_retrain_flag: Retrain link as quirk for PCIe Gen2 * @quirk_detect_quiet_flag: LTSSM Detect Quiet min delay set as quirk drivers/pci/controller/pcie-mediatek-gen3.c +1
-1@@ -303,7 +303,7 @@ static int mtk_pcie_startup_port(struct mtk_pcie_port *port)writel_relaxed (val, port->base +PCIE_RST_CTRL_REG );/* -* Described in PCIe CEM specification setctions 2.2 (PERST# Signal) +* Described in PCIe CEM specification sections 2.2 (PERST# Signal) * and 2.2.1 (Initial Power-Up (G3 to S0)). * The deassertion of PERST# should be delayed 100ms (TPVPERL) * for the power and clock to become stable. drivers/pci/endpoint/functions/pci-epf-ntb.c +1
-1@@ -1262,7 +1262,7 @@ static void epf_ntb_db_mw_bar_cleanup(struct epf_ntb *ntb, }/** -* epf_ntb_configure_interrupt() - Configure MSI/MSI-X capaiblity +* epf_ntb_configure_interrupt() - Configure MSI/MSI-X capability * @ntb: NTB device that facilitates communication between HOST1 and HOST2 * @type: PRIMARY interface or SECONDARY interface * drivers/pci/of.c +1
-1@@ -247,7 +247,7 @@ void of_pci_check_probe_only(void)else pci_clear_flags (PCI_PROBE_ONLY ); -pr_info ("PROBE_ONLY %sabled\n" , val ?"en" :"dis" ); +pr_info ("PROBE_ONLY %s\n" , val ?"enabled" :"disabled" ); }EXPORT_SYMBOL_GPL (of_pci_check_probe_only);drivers/pci/quirks.c +2
-2@@ -980,8 +980,8 @@ static void quirk_via_ioapic(struct pci_dev *dev)else tmp =0x1f ;/* all known bits (4-0) routed to external APIC */ -pci_info (dev,"%sbling VIA external APIC routing\n" , - tmp ==0 ?"Disa" :"Ena" ); +pci_info (dev,"%s VIA external APIC routing\n" , + tmp ==0 ?"Disabling" :"Enabling" );/* Offset 0x58: External APIC IRQ output control */ pci_write_config_byte (dev,0x58 , tmp);Signature · 1 line
2.34.1