Skip to contentSkip to conversation

arm: dts: logicpd-torpedo: Add isp1763 support to baseboard

PATCH In review Adam Ford 2 participants 2 messages Feb 10, 2022 – Feb 18, 2022 Device tree bindings

lore
Share & tools
lore

Adam Ford

author
#0 lore raw

PATCH 1/1 arm: dts: logicpd-torpedo: Add isp1763 support to baseboard

The baseboard has an ISP1763 USB controller acting as a host. Since the pinmuxing for the corresponding IRQ is different between OMAP35 and DM37, the pinmux has been placed in the kit-level files, while the common code is placed into the baseboard file.

arch/arm/boot/dts/logicpd-torpedo-35xx-devkit.dts +8 -0
index 57bae2aa910e..cb08aa62d967 100644
@@ -11,3 +11,11 @@ / {
 	model = "LogicPD Zoom OMAP35xx Torpedo Development Kit";
 	compatible = "logicpd,dm3730-torpedo-devkit", "ti,omap3430", "ti,omap3";
 };
+
+&omap3_pmx_core {
+	isp1763_pins: pinmux_isp1763_pins {
+		pinctrl-single,pins = <
+			OMAP3_CORE1_IOPAD(0x2154,  PIN_INPUT_PULLUP | MUX_MODE4)	/* sdmmc1_dat6.gpio_128 */
+		>;
+	};
+};
arch/arm/boot/dts/logicpd-torpedo-37xx-devkit.dts +9 -0
index 5532db04046c..07ea822fe405 100644
@@ -85,3 +85,12 @@ OMAP3630_CORE2_IOPAD(0x25da, PIN_INPUT_PULLUP | MUX_MODE2)   /* etk_ctl.sdmmc3_c
 		>;
 	};
 };
+
+/* The gpio muxing between omap3530 and dm3730 is different for GPIO_128 */
+&omap3_pmx_wkup {
+	isp1763_pins: pinmux_isp1763_pins {
+		pinctrl-single,pins = <
+			OMAP3_WKUP_IOPAD(0x2a58, PIN_INPUT_PULLUP | MUX_MODE4)	/* reserved.gpio_128 */
+		>;
+	};
+};
arch/arm/boot/dts/logicpd-torpedo-baseboard.dtsi +40 -1

53 lines not on this page · raw message

Signature · 1 line
2.32.0
#1 lore raw
Quoted 5 lines · Adam Ford

The baseboard has an ISP1763 USB controller acting as a host. Since the pinmuxing for the corresponding IRQ is different between OMAP35 and DM37, the pinmux has been placed in the kit-level files, while the common code is placed into the baseboard file.

Applying into omap-for-v5.18/dt thanks.

BTW, there's a chance that your board has the external dma request lines wired up to ISP1763, if so you might be able to configure dmaengine to use it with sdma.

Regards,

Tony