linux-next: manual merge of the nand tree with the mtd tree
[email protected]
maintainerHi all,
Today's linux-next merge of the nand tree got a conflict in:
Documentation/devicetree/bindings/mtd/nand-controller.yaml
between commit:
751f204a6fe6f ("dt-bindings: mtd: nand-chip: Create a NAND chip description")
from the mtd tree and commit:
cb57fae479be4 ("dt-binding: mtd: nand: Document the wp-gpios property")
from the nand tree.
I fixed it up (see below) and can carry the fix as necessary. This is now fixed as far as linux-next is concerned, but any non trivial conflicts should be mentioned to your upstream maintainer when your tree is submitted for merging. You may also want to consider cooperating with the maintainer of the conflicting tree to minimise any particularly complex conflicts.
Documentation/devicetree/bindings/mtd/nand-controller.yaml +0 -0
@@@ -116,6 -154,20 +116,13 @@@ patternProperties Ready/Busy pins. Active state refers to the NAND ready state and should be set to GPIOD_ACTIVE_HIGH unless the signal is inverted. + wp-gpios: + description: + Contains one GPIO descriptor for the Write Protect pin. + Active state refers to the NAND Write Protect state and should be + set to GPIOD_ACTIVE_LOW unless the signal is inverted. + maxItems: 1 + - secure-regions: - $ref: /schemas/types.yaml#/definitions/uint64-matrix - description: - Regions in the NAND chip which are protected using a secure element - like Trustzone. This property contains the start address and size of - the secure regions present. - required: - reg
Miquel Raynal
maintainerHello,
[email protected] wrote on Mon, 21 Feb 2022 13:55:52 +0000:
Quoted 14 lines
Hi all,
Today's linux-next merge of the nand tree got a conflict in:
Documentation/devicetree/bindings/mtd/nand-controller.yamlbetween commit:
751f204a6fe6f("dt-bindings: mtd: nand-chip: Create a NAND chip description")from the mtd tree and commit:
cb57fae479be4("dt-binding: mtd: nand: Document the wp-gpios property")
Quoted 8 lines
from the nand tree.
I fixed it up (see below) and can carry the fix as necessary. This is now fixed as far as linux-next is concerned, but any non trivial conflicts should be mentioned to your upstream maintainer when your tree is submitted for merging. You may also want to consider cooperating with the maintainer of the conflicting tree to minimise any particularly complex conflicts.
Thanks for fixing it up in -next. We will anyway merge the NAND tree into the MTD tree before sending a unique PR so Linus won't have to handle it.
Quoted 16 lines
Documentation/devicetree/bindings/mtd/nand-controller.yaml +6
-0@@@ -116,6 -154,20 +116,13 @@@ patternProperties Ready/Busy pins. Active state refers to the NAND ready state and should be set to GPIOD_ACTIVE_HIGH unless the signal is inverted. + wp-gpios: + description: + Contains one GPIO descriptor for the Write Protect pin. + Active state refers to the NAND Write Protect state and should be + set to GPIOD_ACTIVE_LOW unless the signal is inverted. + maxItems: 1
Documentation/devicetree/bindings/mtd/nand-controller.yaml
Quoted 10 lines
Documentation/devicetree/bindings/mtd/nand-controller.yaml +1
-0+ - secure-regions: - $ref: /schemas/types.yaml#/definitions/uint64-matrix - description: - Regions in the NAND chip which are protected using a secure element - like Trustzone. This property contains the start address and size of - the secure regions present. - required: - reg
Thanks,
Miquèl