i2c: qcom-geni: remove unnecessary conditions
Subsystems (4)
PATCH 1/1 i2c: qcom-geni: remove unnecessary conditions
We know that "ret" is a negative error code at this point so there is no need to check.
Signed-off-by Dan Carpenter <[email protected]>
--- drivers/i2c/busses/i2c-qcom-geni.c | 6 ++---- 1 file changed, 2 insertions(+), 4 deletions(-)
drivers/i2c/busses/i2c-qcom-geni.c +2 -4
@@ -727,16 +727,14 @@ static int setup_gpi_dma(struct geni_i2c_dev *gi2c)if (IS_ERR (gi2c->tx_c)) { ret =dev_err_probe (gi2c->se.dev,PTR_ERR (gi2c->tx_c),"Failed to get tx DMA ch\n" ); -if (ret <0 ) - goto err_tx; + goto err_tx; } gi2c->rx_c =dma_request_chan (gi2c->se.dev,"rx" );if (IS_ERR (gi2c->rx_c)) { ret =dev_err_probe (gi2c->se.dev,PTR_ERR (gi2c->rx_c),"Failed to get rx DMA ch\n" ); -if (ret <0 ) - goto err_rx; + goto err_rx; }dev_dbg (gi2c->se.dev,"Grabbed GPI dma channels\n" );
Signature · 1 line
2.20.1
Wolfram Sang
AppliedQuoted 4 lines · Dan Carpenter
We know that "ret" is a negative error code at this point so there is no need to check.
Signed-off-by Dan Carpenter <[email protected]>
Applied to for-next, thanks!