mtd: spi: Add ISSI QSPI to lightweight SPI flash stack for spl
PATCH 1/1 mtd: spi: Add ISSI QSPI to lightweight SPI flash stack for spl
From: "Lokanathan, Raaj" <[email protected]>
Add support for reading data/images from this ISSI QSPI flash.
Signed-off-by Lokanathan, Raaj <[email protected]>
--- drivers/mtd/spi/spi-nor-tiny.c | 6 ++++-- 1 file changed, 4 insertions(+), 2 deletions(-)
drivers/mtd/spi/spi-nor-tiny.c +4 -2
@@ -219,6 +219,7 @@ static inline int set_4byte(struct spi_nor *nor, const struct flash_info *info,case SNOR_MFR_MICRON :/* Some Micron need WREN command; all will accept it */ need_wren = true; +case SNOR_MFR_ISSI :case SNOR_MFR_MACRONIX :case SNOR_MFR_WINBOND :if (need_wren)
@@ -432,7 +433,7 @@ static int spi_nor_write(struct mtd_info *mtd, loff_t to, size_t len,return -ENOTSUPP ; } -#ifdef CONFIG_SPI_FLASH_MACRONIX +#if defined(CONFIG_SPI_FLASH_MACRONIX ) || defined(CONFIG_SPI_FLASH_ISSI )/** * macronix_quad_enable() - set QE bit in Status Register. * @nor: pointer to a 'struct spi_nor'
@@ -661,8 +662,9 @@ static int spi_nor_setup(struct spi_nor *nor, const struct flash_info *info,/* Enable Quad I/O if needed. */ if (spi_nor_get_protocol_width (nor->read_proto) ==4 ) {switch (JEDEC_MFR (info)) { -#ifdef CONFIG_SPI_FLASH_MACRONIX +#if defined(CONFIG_SPI_FLASH_MACRONIX ) || defined(CONFIG_SPI_FLASH_ISSI )case SNOR_MFR_MACRONIX : +case SNOR_MFR_ISSI : err =macronix_quad_enable (nor);break ;#endif
Signature · 1 line
2.25.1
Quoted 4 lines · On Tue, Mar 15, 2022 at 3:03 PM <[email protected]> wrote:
From: "Lokanathan, Raaj" <[email protected]>
Add support for reading data/images from this ISSI QSPI flash.
Look like the patch is doing quad enable for ISSI but the commit head and body seem misleading or confusing. Can you elaborate on the same?
Jagan.