media: staging: atomisp: rework reading the id and revision values

From: Tom Rix <[email protected]>

Clang static analysis reports this representative issue atomisp-ov2722.c:920:3: warning: 3rd function call
argument is an uninitialized value dev_err(&client->dev, "sensor_id_high = 0x%x\n", high); ^~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

high and low are only set when ov2722_read_reg() is successful. Reporting the high value when there is an error is not meaningful. The later read for low is not checked. high and low are or-ed together and checked against a non zero value.

Remove the unneeded error reporting for high. Initialize high and low to 0 and use the id check to determine if the reads were successful

The later read for revision is not checked. If it fails the old high value will be used and the revision will be misreported.

Since the revision is only reported and not checked or stored it is not necessary to return if the read with successful. This makes the ret variable unnecessary so remove it.

Signed-off-by Tom Rix <[email protected]>

---
 .../media/atomisp/i2c/atomisp-ov2722.c        | 20 ++++++++-----------
 1 file changed, 8 insertions(+), 12 deletions(-)

drivers/staging/media/atomisp/i2c/atomisp-ov2722.c +1 -4

index da98094d7094..d5d099ac1b70 100644
@@ -906,22 +906,17 @@ static int ov2722_get_fmt(struct v4l2_subdev *sd,
 static int ov2722_detect(struct i2c_client *client)
 {
 	struct i2c_adapter *adapter = client->adapter;
-	u16 high, low;
-	int ret;
+	u16 high = 0, low = 0;
 	u16 id;
 	u8 revision;
 
 	if (!i2c_check_functionality(adapter, I2C_FUNC_I2C))
 		return -ENODEV;
 
-	ret = ov2722_read_reg(client, OV2722_8BIT,
-			      OV2722_SC_CMMN_CHIP_ID_H, &high);

drivers/staging/media/atomisp/i2c/atomisp-ov2722.c +0 -0

 	id = (high << 8) | low;
 
 	if ((id != OV2722_ID) && (id != OV2720_ID)) {

@@ -929,8 +924,9 @@ static int ov2722_detect(struct i2c_client *client)
 		return -ENODEV;