man: 'allow to' -> 'allow one to'
Subsystems (2)
PATCH 1/2 man: 'allow to' -> 'allow one to'
From: Luca Boccassi <[email protected]>
Lintian warnings:
I: iproute2: typo-in-manual-page usr/share/man/man8/tc-ctinfo.8.gz line 61 "allow to" "allow one to"
I: iproute2: typo-in-manual-page usr/share/man/man8/tc-netem.8.gz line 70 "allow to" "allow one to"
I: iproute2: typo-in-manual-page usr/share/man/man8/tc-netem.8.gz line 90 "allow to" "allow one to"
I: iproute2: typo-in-manual-page usr/share/man/man8/tc-pedit.8.gz line 307 "allow to" "allow one to"
I: iproute2: typo-in-manual-page usr/share/man/man8/tc-skbmod.8.gz line 66 "allow to" "allow one to"
I: iproute2: typo-in-manual-page usr/share/man/man8/tc-vlan.8.gz line 48 "allow to" "allow one to"
I: iproute2: typo-in-manual-page usr/share/man/man8/tc.8.gz line 346 "allow to" "allow one to"
---
Lintian nags me, so it's only fair that I then nag you
man/man8/tc-ctinfo.8 | 2 +- man/man8/tc-netem.8 | 4 ++-- man/man8/tc-pedit.8 | 2 +- man/man8/tc-skbmod.8 | 2 +- man/man8/tc-vlan.8 | 2 +- man/man8/tc.8 | 2 +- 6 files changed, 7 insertions(+), 7 deletions(-)
man/man8/tc-ctinfo.8 +1 -1
@@ -58,7 +58,7 @@ Specify the conntrack zone when doing conntrack lookups for packets. zone is a 16bit unsigned decimal value. Default is 0. .IP CONTROL -The following keywords allow to control how the tree of qdisc, classes, +The following keywords allow one to control how the tree of qdisc, classes, filters and actions is further traversed after this action. .RS .TP
man/man8/tc-netem.8 +2 -2
@@ -67,7 +67,7 @@ NetEm \- Network Emulator .SH DESCRIPTION NetEm is an enhancement of the Linux traffic control facilities -that allow to add delay, packet loss, duplication and more other +that allow one to add delay, packet loss, duplication and more other characteristics to packets outgoing from a selected network interface. NetEm is built using the existing Quality Of Service (QOS) and Differentiated Services (diffserv) facilities in the Linux
@@ -87,7 +87,7 @@ Delay and jitter values are expressed in ms while correlation is percentage. .SS distribution allow the user to choose the delay distribution. If not specified, the default -distribution is Normal. Additional parameters allow to consider situations in +distribution is Normal. Additional parameters allow one to consider situations in which network has variable delays depending on traffic flows concurring on the same path, that causes several delay peaks and a tail.
man/man8/tc-pedit.8 +1 -1
@@ -304,7 +304,7 @@ allows one to exclude bits from being changed. Supported only for 32 bits fields or smaller. .TP .I CONTROL -The following keywords allow to control how the tree of qdisc, classes, +The following keywords allow one to control how the tree of qdisc, classes, filters and actions is further traversed after this action. .RS .TP
man/man8/tc-skbmod.8 +1 -1
@@ -63,7 +63,7 @@ Used to mark ECN Capable Transport (ECT) IP packets as Congestion Encountered (C Does not affect Non ECN-Capable Transport (Non-ECT) packets. .TP .I CONTROL -The following keywords allow to control how the tree of qdisc, classes, +The following keywords allow one to control how the tree of qdisc, classes, filters and actions is further traversed after this action. .RS .TP
man/man8/tc-vlan.8 +1 -1
@@ -45,7 +45,7 @@ outer-most VLAN encapsulation. The .IR PUSH " and " MODIFY modes require at least a .I VLANID -and allow to optionally choose the +and allow one to optionally choose the .I VLANPROTO to use.
man/man8/tc.8 +1 -1
@@ -343,7 +343,7 @@ band is not stopped prior to dequeuing a packet. .TP netem Network Emulator is an enhancement of the Linux traffic control facilities that -allow to add delay, packet loss, duplication and more other characteristics to +allow one to add delay, packet loss, duplication and more other characteristics to packets outgoing from a selected network interface. .TP pfifo_fast
Signature · 1 line
2.34.1
PATCH 2/2 man: use quote instead of acute accent
From: Luca Boccassi <[email protected]>
Lintian complains:
I: iproute2: acute-accent-in-manual-page usr/share/man/man8/tc-bpf.8.gz:220
"This manual page uses the \' groff sequence. Usually, the intent to
generate an apostrophe, but that sequence actually renders as an acute accent.
For an apostrophe or a single closing quote, use plain '. For single opening quote, i.e. a straight downward line ' like the one used in shell commands, use '\(aq'."
Before:
´s,c t f k,c t f k,c t f k,...´
After:
's,c t f k,c t f k,c t f k,...'
---
Maybe this was the original intention, maybe not, but Lintian nags me, so let's fix it
man/man8/tc-bpf.8 | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)
man/man8/tc-bpf.8 +1 -1
@@ -217,7 +217,7 @@ identifiers which would need to reparse packet contents. .SS bytecode is being used for loading cBPF classifier and actions only. The cBPF bytecode is directly passed as a text string in the form of -.B \'s,c t f k,c t f k,c t f k,...\' +.B \(aqs,c t f k,c t f k,c t f k,...' , where .B s denotes the number of subsequent 4-tuples. One such 4-tuple consists of
Signature · 1 line
2.34.1