arm64: document the boot requirements for MTE
PATCH v2 1/1 arm64: document the boot requirements for MTE
When booting the kernel we access system registers such as GCR_EL1 if MTE is supported. These accesses are defined to trap to EL3 if SCR_EL3.ATA is disabled. Furthermore, tag accesses will not behave as expected if SCR_EL3.ATA is not set, or if HCR_EL2.ATA is not set and we were booted at EL1. Therefore, require that these bits are enabled when appropriate.
---
v2:
- only required with FEAT_MTE2
Documentation/arm64/booting.rst | 10 ++++++++++ 1 file changed, 10 insertions(+)
Documentation/arm64/booting.rst +10 -0
@@ -350,6 +350,16 @@ Before jumping into the kernel, the following conditions must be met: - SMCR_EL2.FA64 (bit 31) must be initialised to 0b1. + For CPUs with the Memory Tagging Extension feature (FEAT_MTE2): + + - If EL3 is present: + + - SCR_EL3.ATA (bit 26) must be initialised to 0b1. + + - If the kernel is entered at EL1 and EL2 is present: + + - HCR_EL2.ATA (bit 56) must be initialised to 0b1. + The requirements described above for CPU mode, caches, MMUs, architected timers, coherency and system registers apply to all CPUs. All CPUs must enter the kernel in the same exception level. Where the values documented
Signature · 7 lines
2.36.0.rc2.479.g8af0fa9b8e-goog _______________________________________________ linux-arm-kernel mailing list [email protected] http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
Catalin Marinas
AppliedQuoted 8 lines · Peter Collingbourne
When booting the kernel we access system registers such as
GCR_EL1if MTE is supported. These accesses are defined to trap to EL3 if SCR_EL3.ATA is disabled. Furthermore, tag accesses will not behave as expected if SCR_EL3.ATA is not set, or if HCR_EL2.ATA is not set and we were booted at EL1. Therefore, require that these bits are enabled when appropriate.[...]
Applied to arm64 (for-next/misc), thanks!
[1/1] arm64: document the boot requirements for MTE
https://git.kernel.org/arm64/c/b6ba1a89f73f
Signature · 1 line
Catalin