arm64: dts: imx8mm-beacon: Enable RTS-CTS on UART3
Subsystems (2)
PATCH 1/2 arm64: dts: imx8mm-beacon: Enable RTS-CTS on UART3
There is a header for a DB9 serial port, but any attempts to use hardware handshaking fail. Enable RTS and CTS pin muxing and enable handshaking in the uart node.
arch/arm64/boot/dts/freescale/imx8mm-beacon-baseboard.dtsi +3 -0
@@ -278,6 +278,7 @@ &uart3 { pinctrl-0 = <&pinctrl_uart3>; assigned-clocks = <&clk IMX8MM_CLK_UART3>; assigned-clock-parents = <&clk IMX8MM_SYS_PLL1_80M>; + uart-has-rtscts; status = "okay"; };
@@ -386,6 +387,8 @@ pinctrl_uart3: uart3grp { fsl,pins = < MX8MM_IOMUXC_ECSPI1_SCLK_UART3_DCE_RX 0x40 MX8MM_IOMUXC_ECSPI1_MOSI_UART3_DCE_TX 0x40 + MX8MM_IOMUXC_ECSPI1_MISO_UART3_DCE_CTS_B 0x40 + MX8MM_IOMUXC_ECSPI1_SS0_UART3_DCE_RTS_B 0x40 >; };
Signature · 7 lines
2.34.1 _______________________________________________ linux-arm-kernel mailing list [email protected] http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
PATCH 2/2 arm64: dts: imx8mn-beacon: Enable RTS-CTS on UART3
There is a header for a DB9 serial port, but any attempts to use hardware handshaking fail. Enable RTS and CTS pin muxing and enable handshaking in the uart node.
arch/arm64/boot/dts/freescale/imx8mn-beacon-baseboard.dtsi +3 -0
@@ -175,6 +175,7 @@ &uart3 { pinctrl-0 = <&pinctrl_uart3>; assigned-clocks = <&clk IMX8MN_CLK_UART3>; assigned-clock-parents = <&clk IMX8MN_SYS_PLL1_80M>; + uart-has-rtscts; status = "okay"; };
@@ -258,6 +259,8 @@ pinctrl_uart3: uart3grp { fsl,pins = < MX8MN_IOMUXC_ECSPI1_SCLK_UART3_DCE_RX 0x40 MX8MN_IOMUXC_ECSPI1_MOSI_UART3_DCE_TX 0x40 + MX8MN_IOMUXC_ECSPI1_MISO_UART3_DCE_CTS_B 0x40 + MX8MN_IOMUXC_ECSPI1_SS0_UART3_DCE_RTS_B 0x40 >; };
Signature · 7 lines
2.34.1 _______________________________________________ linux-arm-kernel mailing list [email protected] http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
Shawn Guo
AppliedQuoted 5 lines · Adam Ford
There is a header for a DB9 serial port, but any attempts to use hardware handshaking fail. Enable RTS and CTS pin muxing and enable handshaking in the uart node.
Signed-off-by Adam Ford <[email protected]>
Applied both, thanks!
_______________________________________________
linux-arm-kernel mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel