i2c: add support for microchip fpga i2c controllers
Subsystems (2)
PATCH v4 1/1 i2c: add support for microchip fpga i2c controllers
Add Microchip CoreI2C i2c controller support. This driver supports the "hard" i2c controller on the Microchip PolarFire SoC & the basic feature set for "soft" i2c controller implemtations in the FPGA fabric.
---
Changes from v3:
- update variables in struct doc comment & reordered them in the struct
- move mchp_corei2c_transfer in its caller
- change msg_len to a u16
- remove unused variable msg_read
- use adapater.timeout for completion
- dropped gotos in irq handler, replaced both with flags.
- remove block on zero length messages
(the hardware can do them, was a carryover from the baremetal driver)
- probe:
- drop unneeded initialisation
- use ret not val
- explain shared irq
- disallow 0 bus_clock_rate
- include base in device name
- dropped the duplicate "microchip" in the registered print (its in driver.name)
Changes from v2:
- Fixed whitespace in defines that I removed accidentally
Changes from v1:
- Use byte write and read functions
- Return IRQ_NONE and don't warn if not this drivers interrupt
- Add a clk_disable_unprepare to avoid leaking a clock in the probe
--- drivers/i2c/busses/Kconfig | 11 + drivers/i2c/busses/Makefile | 1 + drivers/i2c/busses/i2c-microchip-core.c | 486 ++++++++++++++++++++++++ 3 files changed, 498 insertions(+) create mode 100644 drivers/i2c/busses/i2c-microchip-core.c
drivers/i2c/busses/Kconfig +11 -0
@@ -781,6 +781,17 @@ config I2C_MESON If you say yes to this option, support will be included for the I2C interface on the Amlogic Meson family of SoCs. +config I2C_MICROCHIP_CORE + tristate "Microchip FPGA I2C controller" + depends on SOC_MICROCHIP_POLARFIRE || COMPILE_TEST + depends on OF + help + If you say yes to this option, support will be included for the + I2C interface on Microchip FPGAs. + + This driver can also be built as a module. If so, the module will be + called i2c-microchip-core. + config I2C_MPC tristate "MPC107/824x/85xx/512x/52xx/83xx/86xx" depends on PPC
drivers/i2c/busses/Makefile +1 -0
@@ -78,6 +78,7 @@ obj-$(CONFIG_I2C_JZ4780) += i2c-jz4780.o obj-$(CONFIG_I2C_KEMPLD) += i2c-kempld.o obj-$(CONFIG_I2C_LPC2K) += i2c-lpc2k.o obj-$(CONFIG_I2C_MESON) += i2c-meson.o +obj-$(CONFIG_I2C_MICROCHIP_CORE) += i2c-microchip-core.o obj-$(CONFIG_I2C_MPC) += i2c-mpc.o obj-$(CONFIG_I2C_MT65XX) += i2c-mt65xx.o obj-$(CONFIG_I2C_MT7621) += i2c-mt7621.o
drivers/i2c/busses/i2c-microchip-core.c new file +486 -0
486 lines not on this page · raw message
Signature · 1 line
2.36.1