can: Break loopback loop on loopback documentation
Subsystems (4)
PATCH 1/1 can: Break loopback loop on loopback documentation
There are two sections called "Local Loopback of Sent Frames". One was meant to link to the other, but pointed at itself instead.
Signed-off-by Max Staudt <[email protected]>
--- Documentation/networking/can.rst | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)
Documentation/networking/can.rst +1 -1
@@ -168,7 +168,7 @@ reflect the correct [#f1]_ traffic on the node the loopback of the sent data has to be performed right after a successful transmission. If the CAN network interface is not capable of performing the loopback for some reason the SocketCAN core can do this task as a fallback solution. -See :ref:`socketcan-local-loopback1` for details (recommended). +See :ref:`socketcan-local-loopback2` for details (recommended). The loopback functionality is enabled by default to reflect standard networking behaviour for CAN applications. Due to some requests from
Signature · 1 line
2.30.2
Marc Kleine-Budde
maintainerQuoted 4 lines · Max Staudt
There are two sections called "Local Loopback of Sent Frames". One was meant to link to the other, but pointed at itself instead.
Signed-off-by Max Staudt <[email protected]>
Applied to can-next/testing.
Thanks,
Marc
Signature · 4 lines
Pengutronix e.K. | Marc Kleine-Budde | Embedded Linux | https://www.pengutronix.de | Vertretung West/Dortmund | Phone: +49-231-2826-924 | Amtsgericht Hildesheim, HRA 2686 | Fax: +49-5121-206917-5555 |