Skip to contentSkip to conversation

dt-bindings: interrupt-controller: Convert rda,8810pl-intc to YAML

PATCH Applied Stanislav Jakubek 3 participants 3 messages Jun 11, 2022 – Jun 16, 2022

Subsystems (3)
Device tree bindings irqchip drivers Arm/rda micro architecture
lore
Share & tools
lore

Stanislav Jakubek

author
#0 lore raw

PATCH v2 1/1 dt-bindings: interrupt-controller: Convert rda,8810pl-intc to YAML

Convert RDA Micro interrupt controller bindings to DT schema format.

Signed-off-by Stanislav Jakubek <[email protected]>

---

Changes in v2:
- drop the interrupt sources header file

 .../interrupt-controller/rda,8810pl-intc.txt  | 61 -------------------
 .../interrupt-controller/rda,8810pl-intc.yaml | 43 +++++++++++++
 MAINTAINERS                                   |  2 +-
 3 files changed, 44 insertions(+), 62 deletions(-)
 delete mode 100644 Documentation/devicetree/bindings/interrupt-controller/rda,8810pl-intc.txt
 create mode 100644 Documentation/devicetree/bindings/interrupt-controller/rda,8810pl-intc.yaml
Documentation/devicetree/bindings/interrupt-controller/rda,8810pl-intc.txt deleted +0 -61
deleted file mode 100644
index e0062aebf025..000000000000
@@ -1,61 +0,0 @@
-RDA Micro RDA8810PL Interrupt Controller
-
-The interrupt controller in RDA8810PL SoC is a custom interrupt controller
-which supports up to 32 interrupts.
-
-Required properties:
-
-- compatible: Should be "rda,8810pl-intc".
-- reg: Specifies base physical address of the registers set.
-- interrupt-controller: Identifies the node as an interrupt controller.
-- #interrupt-cells: Specifies the number of cells needed to encode an
-  interrupt source. The value shall be 2.
-
-The interrupt sources are as follows:
-
-ID	Name
-------------
-0:	PULSE_DUMMY
-1:	I2C
-2:	NAND_NFSC
-3:	SDMMC1
-4:	SDMMC2
-5:	SDMMC3
-6:	SPI1
-7:	SPI2
-8:	SPI3
-9:	UART1
-10:	UART2
-11:	UART3
-12:	GPIO1
-13:	GPIO2
-14:	GPIO3
-15:	KEYPAD
-16:	TIMER
-17:	TIMEROS
-18:	COMREG0
-19:	COMREG1
-20:	USB
-21:	DMC
-22:	DMA
-23:	CAMERA
-24:	GOUDA
-25:	GPU
-26:	VPU_JPG
-27:	VPU_HOST
-28:	VOC
-29:	AUIFC0
-30:	AUIFC1
-31:	L2CC
-
-Example:
-		apb@20800000 {
-			compatible = "simple-bus";
-			...
-			intc: interrupt-controller@0 {
-				compatible = "rda,8810pl-intc";
-				reg = <0x0 0x1000>;
-				interrupt-controller;
-				#interrupt-cells = <2>;
-			};
-		};
Documentation/devicetree/bindings/interrupt-controller/rda,8810pl-intc.yaml new file +43 -0

43 lines not on this page · raw message

MAINTAINERS +1 -1
index f0a90b256b26..58a35519b7c4 100644
@@ -2590,7 +2590,7 @@ L:	[email protected] (moderated for non-subscribers)
 S:	Maintained
 F:	Documentation/devicetree/bindings/arm/rda.yaml
 F:	Documentation/devicetree/bindings/gpio/gpio-rda.yaml
-F:	Documentation/devicetree/bindings/interrupt-controller/rda,8810pl-intc.txt
+F:	Documentation/devicetree/bindings/interrupt-controller/rda,8810pl-intc.yaml
 F:	Documentation/devicetree/bindings/serial/rda,8810pl-uart.yaml
 F:	Documentation/devicetree/bindings/timer/rda,8810pl-timer.yaml
 F:	arch/arm/boot/dts/rda8810pl-*
Signature · 1 line
2.25.1
maintainer Applied
#1 lore raw
Quoted 8 lines · Stanislav Jakubek

Convert RDA Micro interrupt controller bindings to DT schema format.

Signed-off-by Stanislav Jakubek <[email protected]>

---

Changes in v2:
- drop the interrupt sources header file

Quoted 7 lines
 .../interrupt-controller/rda,8810pl-intc.txt  | 61 -------------------
 .../interrupt-controller/rda,8810pl-intc.yaml | 43 +++++++++++++
 MAINTAINERS                                   |  2 +-
 3 files changed, 44 insertions(+), 62 deletions(-)
 delete mode 100644 Documentation/devicetree/bindings/interrupt-controller/rda,8810pl-intc.txt
 create mode 100644 Documentation/devicetree/bindings/interrupt-controller/rda,8810pl-intc.yaml

Applied, thanks!

maintainer Reviewed-by on v2 1/1
#2 lore raw
In reply to Stanislav Jakubek
Quoted 3 lines · Stanislav Jakubek

Convert RDA Micro interrupt controller bindings to DT schema format.

Signed-off-by Stanislav Jakubek <[email protected]>
Reviewed-by Manivannan Sadhasivam <[email protected]>

Thanks,
Mani

Quoted 144 lines

---

Changes in v2:
- drop the interrupt sources header file

 .../interrupt-controller/rda,8810pl-intc.txt  | 61 -------------------
 .../interrupt-controller/rda,8810pl-intc.yaml | 43 +++++++++++++
 MAINTAINERS                                   |  2 +-
 3 files changed, 44 insertions(+), 62 deletions(-)
 delete mode 100644 Documentation/devicetree/bindings/interrupt-controller/rda,8810pl-intc.txt
 create mode 100644 Documentation/devicetree/bindings/interrupt-controller/rda,8810pl-intc.yaml
Documentation/devicetree/bindings/interrupt-controller/rda,8810pl-intc.txt deleted +0 -61
deleted file mode 100644
index e0062aebf025..000000000000
@@ -1,61 +0,0 @@
-RDA Micro RDA8810PL Interrupt Controller
-
-The interrupt controller in RDA8810PL SoC is a custom interrupt controller
-which supports up to 32 interrupts.
-
-Required properties:
-
-- compatible: Should be "rda,8810pl-intc".
-- reg: Specifies base physical address of the registers set.
-- interrupt-controller: Identifies the node as an interrupt controller.
-- #interrupt-cells: Specifies the number of cells needed to encode an
-  interrupt source. The value shall be 2.
-
-The interrupt sources are as follows:
-
-ID	Name
-------------
-0:	PULSE_DUMMY
-1:	I2C
-2:	NAND_NFSC
-3:	SDMMC1
-4:	SDMMC2
-5:	SDMMC3
-6:	SPI1
-7:	SPI2
-8:	SPI3
-9:	UART1
-10:	UART2
-11:	UART3
-12:	GPIO1
-13:	GPIO2
-14:	GPIO3
-15:	KEYPAD
-16:	TIMER
-17:	TIMEROS
-18:	COMREG0
-19:	COMREG1
-20:	USB
-21:	DMC
-22:	DMA
-23:	CAMERA
-24:	GOUDA
-25:	GPU
-26:	VPU_JPG
-27:	VPU_HOST
-28:	VOC
-29:	AUIFC0
-30:	AUIFC1
-31:	L2CC
-
-Example:
-		apb@20800000 {
-			compatible = "simple-bus";
-			...
-			intc: interrupt-controller@0 {
-				compatible = "rda,8810pl-intc";
-				reg = <0x0 0x1000>;
-				interrupt-controller;
-				#interrupt-cells = <2>;
-			};
-		};
Documentation/devicetree/bindings/interrupt-controller/rda,8810pl-intc.yaml new file +43 -0
new file mode 100644
index 000000000000..96d6285d0087
@@ -0,0 +1,43 @@
+# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
+%YAML 1.2
+---
+$id: http://devicetree.org/schemas/interrupt-controller/rda,8810pl-intc.yaml#
+$schema: http://devicetree.org/meta-schemas/core.yaml#
+
+title: RDA Micro RDA8810PL interrupt controller
+
+maintainers:
+  - Manivannan Sadhasivam <[email protected]>
+
+allOf:
+  - $ref: /schemas/interrupt-controller.yaml#
+
+properties:
+  compatible:
+    const: rda,8810pl-intc
+
+  reg:
+    maxItems: 1
+
+  interrupt-controller: true
+
+  '#interrupt-cells':
+    const: 2
+
+required:
+  - compatible
+  - reg
+  - interrupt-controller
+  - '#interrupt-cells'
+
+additionalProperties: false
+
+examples:
+  - |
+    intc: interrupt-controller@0 {
+      compatible = "rda,8810pl-intc";
+      reg = <0x0 0x1000>;
+      interrupt-controller;
+      #interrupt-cells = <2>;
+    };
+...
MAINTAINERS +1 -1
index f0a90b256b26..58a35519b7c4 100644
@@ -2590,7 +2590,7 @@ L:	[email protected] (moderated for non-subscribers)
 S:	Maintained
 F:	Documentation/devicetree/bindings/arm/rda.yaml
 F:	Documentation/devicetree/bindings/gpio/gpio-rda.yaml
-F:	Documentation/devicetree/bindings/interrupt-controller/rda,8810pl-intc.txt
+F:	Documentation/devicetree/bindings/interrupt-controller/rda,8810pl-intc.yaml
 F:	Documentation/devicetree/bindings/serial/rda,8810pl-uart.yaml
 F:	Documentation/devicetree/bindings/timer/rda,8810pl-timer.yaml
 F:	arch/arm/boot/dts/rda8810pl-*
Signature · 1 line
2.25.1
Signature · 1 line
மணிவண்ணன் சதாசிவம்