Skip to contentSkip to conversation

arm: milbeaut: remove select of non-existing PINCTRL_MILBEAUT

PATCH New Lukas Bulwahn 1 participant 1 message Jul 11, 2022

Subsystems (4)
lore
Share & tools
lore
#0 lore raw

PATCH 1/1 arm: milbeaut: remove select of non-existing PINCTRL_MILBEAUT

The patch series "Add basic support for Socionext Milbeaut M10V SoC" (see Link) introduced the config ARCH_MILBEAUT_M10V "Milbeaut SC2000/M10V platform" in ./arch/arm/mach-milbeaut/ and intended to introduce timer, clock, pinctrl and serial controller drivers.

However, during patch submission in March 2019, the introduction of the milbeaut pinctrl driver was dropped from v2 to v3 of the patch series. Since then, there was no further patch series to add this pinctrl driver later on.

Hence, selecting PINCTRL_MILBEAUT in config is simply dangling and referring to a non-existing config symbols. Fortunately, ./scripts/checkkconfigsymbols.py warns:

PINCTRL_MILBEAUT
Referencing files: arch/arm/mach-milbeaut/Kconfig

Remove this select of the non-existing PINCTRL_MILBEAUT for now.

---
Russell, please pick this minor non-urgent clean-up patch.

 arch/arm/mach-milbeaut/Kconfig | 1 -
 1 file changed, 1 deletion(-)
arch/arm/mach-milbeaut/Kconfig +0 -1
index 6a576fd8521e..f9d1006f9442 100644
@@ -13,7 +13,6 @@ config ARCH_MILBEAUT_M10V
 	select ARM_ARCH_TIMER
 	select MILBEAUT_TIMER
 	select PINCTRL
-	select PINCTRL_MILBEAUT
 	help
 	  Support for Socionext's MILBEAUT M10V based systems
 
Signature · 1 line
2.17.1