powerpc: dts: turris1x.dts: Add CPLD reboot node
Subsystems (2)
PATCH 1/1 powerpc: dts: turris1x.dts: Add CPLD reboot node
CPLD firmware can reset board by writing value 0x01 at CPLD memory offset 0x0d. Define syscon-reboot node for this reset support.
Fixes 54c15ec3b738 ("powerpc: dts: Add DTS file for CZ.NIC Turris 1.x routers")
Signed-off-by Pali Rohár <[email protected]>
--- arch/powerpc/boot/dts/turris1x.dts | 10 +++++++++- 1 file changed, 9 insertions(+), 1 deletion(-)
arch/powerpc/boot/dts/turris1x.dts +9 -1
@@ -332,7 +332,7 @@ * Turris CPLD firmware is open source and available at: * https://gitlab.nic.cz/turris/hw/turris_cpld/-/blob/master/CZ_NIC_Router_CPLD.v */ - compatible = "cznic,turris1x-cpld", "fsl,p1021rdb-pc-cpld", "simple-bus"; + compatible = "cznic,turris1x-cpld", "fsl,p1021rdb-pc-cpld", "simple-bus", "syscon"; reg = <0x3 0x0 0x30>; #address-cells = <1>; #size-cells = <1>;
@@ -352,6 +352,14 @@ gpios = <&gpio 11 GPIO_ACTIVE_LOW>; }; + reboot@d { + compatible = "syscon-reboot"; + reg = <0x0d 0x01>; + offset = <0x0d>; + mask = <0x01>; + value = <0x01>; + }; + led-controller@13 { /* * LEDs are controlled by CPLD firmware.
Signature · 1 line
2.20.1
Michael Ellerman
AppliedQuoted 4 lines · Pali Rohár
CPLD firmware can reset board by writing value
0x01at CPLD memory offset0x0d. Define syscon-reboot node for this reset support.
Applied to powerpc/next.
[1/1] powerpc: dts: turris1x.dts: Add CPLD reboot node
https://git.kernel.org/powerpc/c/0531a4abd1c6c2e270f5ac6fc725ff550fcd14ab
cheers