ipv6/addrconf: allow to use SLAAC with prefixes < /64
Subsystems (3)
RFC PATCH 1/1 ipv6/addrconf: allow to use SLAAC with prefixes < /64
This enables SLAAC with prefixes smaller than /64.
SLAAC is performed as usual using only the lower 64 bit of the address for the interface identifier.
The bits not used by the prefix are simply considered 0 (and must be considered 0 as they will be set by downstream subnets).
The idea is to being able to advertise a larger subnet, that can then be autonomously split in a hierarchical fashion by downstream routers. [0]
Signed-off-by Benjamin Valentin <[email protected]>
--- net/ipv6/addrconf.c | 5 +++-- 1 file changed, 3 insertions(+), 2 deletions(-)
net/ipv6/addrconf.c +3 -2
@@ -2787,8 +2787,9 @@ void addrconf_prefix_rcv(struct net_device *dev, u8 *opt, int len, bool sllao)struct in6_addr addr;bool tokenized = false, dev_addr_generated = false; -if (pinfo->prefix_len ==64 ) { -memcpy (&addr, &pinfo->prefix,8 ); +if (pinfo->prefix_len <=64 ) { +memset (&addr,0 ,8 ); +memcpy (&addr, &pinfo->prefix, (pinfo->prefix_len +7 ) /8 );if (!ipv6_addr_any (&in6_dev->token)) {read_lock_bh (&in6_dev->lock);