arm64: dts: imx8mp: Adjust PHY IRQ mode on i.MX8M Plus DHCOM
Subsystems (3)
PATCH 1/1 arm64: dts: imx8mp: Adjust PHY IRQ mode on i.MX8M Plus DHCOM
Set SION bit and clear ODE and DSE bits for PHY IRQ IOMUXC settings. The SION bit is needed to pass pin state into the SoC, the later are not needed as this is an input pin.
--- arch/arm64/boot/dts/freescale/imx8mp-dhcom-som.dtsi | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)
arch/arm64/boot/dts/freescale/imx8mp-dhcom-som.dtsi +1 -1
@@ -778,7 +778,7 @@ pinctrl_ethphy0: dhcom-ethphy0-grp { /* ENET1_#RST Reset */ MX8MP_IOMUXC_SAI5_RXC__GPIO3_IO20 0x22 /* ENET1_#INT Interrupt */ - MX8MP_IOMUXC_SAI5_RXFS__GPIO3_IO19 0x22 + MX8MP_IOMUXC_SAI5_RXFS__GPIO3_IO19 0x40000000 >; };
Signature · 7 lines
2.35.1 _______________________________________________ linux-arm-kernel mailing list [email protected] http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
Quoted 3 lines · Marek Vasut
Set SION bit and clear ODE and DSE bits for PHY IRQ IOMUXC settings. The SION bit is needed to pass pin state into the SoC, the later are not needed as this is an input pin.
I think these two are the right fix for this problem:
https://lore.kernel.org/linux-gpio/[email protected]/
https://lore.kernel.org/linux-gpio/[email protected]/
Please drop this patch.
_______________________________________________
linux-arm-kernel mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel