configs: imx8mm: Define CONFIG_SYS_UBOOT_BASE for i.MX8m
PATCH v6 5/7 configs: imx8mm: Define CONFIG_SYS_UBOOT_BASE for i.MX8m
Quoted 9 lines
The macro
CONFIG_SYS_UBOOT_BASEis used by SPL loaders"NOR"and"XIP"to determine the base address of u-boot.
For"NOR"on i.MX8MM it is the base address of QSPI0 plus the offset of the flattened image tree blob.
AlthoughQSPI0_AMBA_BASEis used to defineCONFIG_SYS_UBOOT_BASEin multiple board header files for i.MX8MM, it is not specified. Specify offset of flattened image tree blob (needs to be set to same value as specified in 'binman' node), base address of QSPI0 and size of FlexSPI configuration block.
Quoted 5 lines
Signed-off-by Mamta Shukla <[email protected]>Signed-off-by Thomas Haemmerle <[email protected]>Tested-by Adam Ford <[email protected]>Reviewed-by Fabio Estevam <[email protected]>Reviewed-by Andrey Zhizhikin <[email protected]>
Applied to u-boot-imx, master, thanks !
Best regards,
Stefano Babic
Signature · 5 lines
===================================================================== DENX Software Engineering GmbH, Managing Director: Wolfgang Denk HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: [email protected] =====================================================================