net/mlx5: fix detection of LRO support
PATCH 1/1 net/mlx5: fix detection of LRO support
One of the conditions to allow LRO offload is the DV configuration.
The function incorrectly checks the DV configuration before initializing it by the user devarg; hence, LRO cannot be allowed.
This patch moves this check to mlx5_shared_dev_ctx_args_config, where DV configuration is initialized.
--- drivers/net/mlx5/linux/mlx5_os.c | 9 --------- drivers/net/mlx5/mlx5.c | 14 ++++++++++---- drivers/net/mlx5/mlx5.h | 2 +- drivers/net/mlx5/mlx5_devx.c | 2 +- drivers/net/mlx5/mlx5_rxq.c | 6 +++--- 5 files changed, 15 insertions(+), 18 deletions(-)
drivers/net/mlx5/linux/mlx5_os.c +0 -9
@@ -369,15 +369,6 @@ mlx5_os_capabilities_prepare(struct mlx5_dev_ctx_shared *sh) "DevX does not provide UAR offset, can't create queues for packet pacing."); sh->dev_cap.txpp_en =0 ;#endif -/* Check for LRO support. */ -if (mlx5_devx_obj_ops_en (sh) && hca_attr->lro_cap) { -/* TBD check tunnel lro caps. */ - sh->dev_cap.lro_supported =1 ; -DRV_LOG (DEBUG ,"Device supports LRO." ); -DRV_LOG (DEBUG , -"LRO minimal size of TCP segment required for coalescing is %d bytes." , - hca_attr->lro_min_mss_size); - } sh->dev_cap.scatter_fcs_w_decap_disable = hca_attr->scatter_fcs_w_decap_disable; sh->dev_cap.rq_delay_drop_en = hca_attr->rq_delay_drop;
drivers/net/mlx5/mlx5.c +10 -4
@@ -1327,6 +1327,15 @@ mlx5_shared_dev_ctx_args_config(struct mlx5_dev_ctx_shared *sh,DRV_LOG (WARNING ,"\"tx_skew\" doesn't affect without \"tx_pp\"." ); } +/* Check for LRO support. */ +if (mlx5_devx_obj_ops_en (sh) && sh->cdev->config.hca_attr.lro_cap) { +/* TBD check tunnel lro caps. */ + config->lro_allowed =1 ; +DRV_LOG (DEBUG ,"LRO is allowed." ); +DRV_LOG (DEBUG , +"LRO minimal size of TCP segment required for coalescing is %d bytes." , + sh->cdev->config.hca_attr.lro_min_mss_size); + }/* * If HW has bug working with tunnel packet decapsulation and scatter * FCS, and decapsulation is needed, clear the hw_fcs_strip bit.
@@ -2392,10 +2401,7 @@ mlx5_port_args_config(struct mlx5_priv *priv, struct mlx5_kvargs_ctrl *mkvlist, config->mps ==MLX5_MPW_ENHANCED ?"enhanced " : config->mps ==MLX5_MPW ?"legacy " :"" , config->mps != MLX5_MPW_DISABLED ? "enabled" : "disabled"); -/* LRO is supported only when DV flow enabled. */ -if (dev_cap->lro_supported && !priv->sh->config.dv_flow_en) - dev_cap->lro_supported =0 ; -if (dev_cap->lro_supported) { +if (priv->sh->config.lro_allowed) {/* * If LRO timeout is not configured by application, * use the minimal supported value.
drivers/net/mlx5/mlx5.h +1 -1
@@ -151,7 +151,6 @@ struct mlx5_dev_cap {/* HW has bug working with tunnel packet decap and scatter FCS. */ uint32_t hw_fcs_strip:1; /* FCS stripping is supported. */ uint32_t rt_timestamp:1; /* Realtime timestamp format. */ - uint32_t lro_supported:1; /* Whether LRO is supported. */ uint32_t rq_delay_drop_en:1; /* Enable RxQ delay drop. */ uint32_t tunnel_en:3;/* Whether tunnel stateless offloads are supported. */
@@ -308,6 +307,7 @@ struct mlx5_sh_config { uint32_t decap_en:1; /* Whether decap will be used or not. */ uint32_t hw_fcs_strip:1; /* FCS stripping is supported. */ uint32_t allow_duplicate_pattern:1; + uint32_t lro_allowed:1; /* Whether LRO is allowed. *//* Allow/Prevent the duplicate rules pattern. */ };
drivers/net/mlx5/mlx5_devx.c +1 -1
@@ -835,7 +835,7 @@ mlx5_devx_tir_attr_set(struct rte_eth_dev *dev, const uint8_t *rss_key,if (dev->data->dev_conf.lpbk_mode) tir_attr->self_lb_block =MLX5_TIRC_SELF_LB_BLOCK_BLOCK_UNICAST ;if (lro) { -MLX5_ASSERT (priv->sh->dev_cap.lro_supported); +MLX5_ASSERT (priv->sh->config.lro_allowed); tir_attr->lro_timeout_period_usecs = priv->config.lro_timeout; tir_attr->lro_max_msg_sz = priv->max_lro_msg_size; tir_attr->lro_enable_mask =
drivers/net/mlx5/mlx5_rxq.c +3 -3
@@ -374,7 +374,7 @@ mlx5_get_rx_queue_offloads(struct rte_eth_dev *dev) RTE_ETH_RX_OFFLOAD_TCP_CKSUM);if (priv->sh->dev_cap.hw_vlan_strip) offloads |=RTE_ETH_RX_OFFLOAD_VLAN_STRIP ; -if (priv->sh->dev_cap.lro_supported) +if (priv->sh->config.lro_allowed) offloads |=RTE_ETH_RX_OFFLOAD_TCP_LRO ;return offloads; }
@@ -843,9 +843,9 @@ mlx5_rx_queue_setup(struct rte_eth_dev *dev, uint16_t idx, uint16_t desc,bool is_extmem = false;if ((offloads &RTE_ETH_RX_OFFLOAD_TCP_LRO ) && - !priv->sh->dev_cap.lro_supported) { + !priv->sh->config.lro_allowed) {DRV_LOG (ERR , -"Port %u queue %u LRO is configured but not supported." , +"Port %u queue %u LRO is configured but not allowed." , dev->data->port_id, idx); rte_errno =EINVAL ;return -rte_errno;
Signature · 1 line
2.25.1
Hi,
Quoted 18 lines
-----Original Message-----
From: Michael Baum <[email protected]>
Sent: Wednesday, July 27, 2022 3:24 PM
To: [email protected]
Cc: Matan Azrad <[email protected]>; Raslan Darawsheh <[email protected]>; Slava Ovsiienko <[email protected]>; Michael Baum <[email protected]>; [email protected]; Gal Shalom <[email protected]>
Subject: [PATCH] net/mlx5: fix detection of LRO supportOne of the conditions to allow LRO offload is the DV configuration.
The function incorrectly checks the DV configuration before initializing it by the user devarg; hence, LRO cannot be allowed.
This patch moves this check to
mlx5_shared_dev_ctx_args_config, where DV configuration is initialized.
Quoted 7 lines
Fixes c4b862013598 ("net/mlx5: refactor to detect operation by DevX")Signed-off-by Michael Baum <[email protected]>Reported-by Gal Shalom <[email protected]>Acked-by Matan Azrad <[email protected]>
Patch applied to next-net-mlx,
Kindest regards,
Raslan Darawsheh