arm64: dts: verdin-imx8mm: add otg2 pd to usbphy
Subsystems (2)
PATCH v2 1/1 arm64: dts: verdin-imx8mm: add otg2 pd to usbphy
From: Philippe Schenker <[email protected]>
The Verdin iMX8M Mini System on Module does not have USB-ID signal connected on Verdin USB_2 (usbotg2). On Verdin Development board this is no problem, as we have connected a USB-Hub that is always connected.
However, if Verdin USB_2 is desired to be used as a single USB-Host port the chipidea driver does not detect if a USB device is plugged into this port, due to runtime pm shutting down the PHY.
Add the power-domain &pgc_otg2 to &usbphynop2 in order to detect plugging events and enumerate the usb device.
---
Changes in v2:
- Changed word VBUS to USB-ID, as from mailinglist discussions I obviously mixed that up before.
arch/arm64/boot/dts/freescale/imx8mm-verdin.dtsi | 1 + 1 file changed, 1 insertion(+)
arch/arm64/boot/dts/freescale/imx8mm-verdin.dtsi +1 -0
@@ -745,6 +745,7 @@ &usbphynop1 { }; &usbphynop2 { + power-domains = <&pgc_otg2>; vcc-supply = <®_vdd_3v3>; };
Signature · 1 line
2.37.1
Shawn Guo
AppliedQuoted 10 lines · Philippe Schenker
From: Philippe Schenker <[email protected]>
The Verdin iMX8M Mini System on Module does not have USB-ID signal connected on Verdin
USB_2(usbotg2). On Verdin Development board this is no problem, as we have connected a USB-Hub that is always connected.However, if Verdin
USB_2is desired to be used as a single USB-Host port the chipidea driver does not detect if a USB device is plugged into this port, due to runtime pm shutting down the PHY.
Quoted 5 lines
Add the power-domain
&pgc_otg2to &usbphynop2 in order to detect plugging events and enumerate the usb device.Fixes 6a57f224f734 ("arm64: dts: freescale: add initial support for verdin imx8m mini")Signed-off-by Philippe Schenker <[email protected]>
Applied, thanks!