Skip to contentSkip to conversation

r8169: fix rtl8125b dmar pte write access not set error

PATCH In review Chunhao Lin 2 participants 2 messages Oct 3, 2022 – Oct 4, 2022

Subsystems (3)
lore
Share & tools
lore
#0 lore raw

PATCH v2 1/1 r8169: fix rtl8125b dmar pte write access not set error

When close device, rx will be enabled if wol is enabeld. When open device it will cause rx to dma to wrong address after pci_set_master().

In this patch, driver will disable tx/rx when close device. If wol is eanbled only enable rx filter and disable rxdv_gate to let hardware can receive packet to fifo but not to dma it.

---
v1 -> v2: limit the call to rtl_disable_rxdvgate()

 drivers/net/ethernet/realtek/r8169_main.c | 58 +++++++++++------------
 1 file changed, 29 insertions(+), 29 deletions(-)
drivers/net/ethernet/realtek/r8169_main.c +29 -29
index a73d061d9fcb..731c5366abc6 100644
@@ -2210,28 +2210,6 @@ static int rtl_set_mac_address(struct net_device *dev, void *p)
 	return 0;
 }
 
-static void rtl_wol_enable_rx(struct rtl8169_private *tp)
-{
-	if (tp->mac_version >= RTL_GIGA_MAC_VER_25)
-		RTL_W32(tp, RxConfig, RTL_R32(tp, RxConfig) |
-			AcceptBroadcast | AcceptMulticast | AcceptMyPhys);
-}
-
-static void rtl_prepare_power_down(struct rtl8169_private *tp)
-{
-	if (tp->dash_type != RTL_DASH_NONE)
-		return;
-
-	if (tp->mac_version == RTL_GIGA_MAC_VER_32 ||
-	    tp->mac_version == RTL_GIGA_MAC_VER_33)
-		rtl_ephy_write(tp, 0x19, 0xff64);
-
-	if (device_may_wakeup(tp_to_dev(tp))) {
-		phy_speed_down(tp->phydev, false);
-		rtl_wol_enable_rx(tp);
-	}
-}
-
 static void rtl_init_rxcfg(struct rtl8169_private *tp)
 {
 	switch (tp->mac_version) {
@@ -2455,6 +2433,31 @@ static void rtl_enable_rxdvgate(struct rtl8169_private *tp)
 	rtl_wait_txrx_fifo_empty(tp);
 }
 
+static void rtl_wol_enable_rx(struct rtl8169_private *tp)
+{
+	if (tp->mac_version >= RTL_GIGA_MAC_VER_25)
+		RTL_W32(tp, RxConfig, RTL_R32(tp, RxConfig) |
+			AcceptBroadcast | AcceptMulticast | AcceptMyPhys);
+
+	if (tp->mac_version >= RTL_GIGA_MAC_VER_40)
+		rtl_disable_rxdvgate(tp);
+}
+
+static void rtl_prepare_power_down(struct rtl8169_private *tp)
+{
+	if (tp->dash_type != RTL_DASH_NONE)
+		return;
+
+	if (tp->mac_version == RTL_GIGA_MAC_VER_32 ||
+	    tp->mac_version == RTL_GIGA_MAC_VER_33)
+		rtl_ephy_write(tp, 0x19, 0xff64);
+
+	if (device_may_wakeup(tp_to_dev(tp))) {
+		phy_speed_down(tp->phydev, false);
+		rtl_wol_enable_rx(tp);
+	}
+}
+
 static void rtl_set_tx_config_registers(struct rtl8169_private *tp)
 {
 	u32 val = TX_DMA_BURST << TxDMAShift |
@@ -3872,7 +3875,7 @@ static void rtl8169_tx_clear(struct rtl8169_private *tp)
 	netdev_reset_queue(tp->dev);
 }
 
-static void rtl8169_cleanup(struct rtl8169_private *tp, bool going_down)
+static void rtl8169_cleanup(struct rtl8169_private *tp)
 {
 	napi_disable(&tp->napi);
 
@@ -3884,9 +3887,6 @@ static void rtl8169_cleanup(struct rtl8169_private *tp, bool going_down)
 
 	rtl_rx_close(tp);
 
-	if (going_down && tp->dev->wol_enabled)
-		goto no_reset;
-
 	switch (tp->mac_version) {
 	case RTL_GIGA_MAC_VER_28:
 	case RTL_GIGA_MAC_VER_31:
@@ -3907,7 +3907,7 @@ static void rtl8169_cleanup(struct rtl8169_private *tp, bool going_down)
 	}
 
 	rtl_hw_reset(tp);
-no_reset:
+
 	rtl8169_tx_clear(tp);
 	rtl8169_init_ring_indexes(tp);
 }
@@ -3918,7 +3918,7 @@ static void rtl_reset_work(struct rtl8169_private *tp)
 
 	netif_stop_queue(tp->dev);
 
-	rtl8169_cleanup(tp, false);
+	rtl8169_cleanup(tp);
 
 	for (i = 0; i < NUM_RX_DESC; i++)
 		rtl8169_mark_to_asic(tp->RxDescArray + i);
@@ -4604,7 +4604,7 @@ static void rtl8169_down(struct rtl8169_private *tp)
 	pci_clear_master(tp->pci_dev);
 	rtl_pci_commit(tp);
 
-	rtl8169_cleanup(tp, true);
+	rtl8169_cleanup(tp);
 	rtl_disable_exit_l1(tp);
 	rtl_prepare_power_down(tp);
 }
Signature · 1 line
2.25.1
maintainer
#1 lore raw
Quoted 10 lines · On Mon, 3 Oct 2022 15:03:33 +0800 Chunhao Lin wrote:

When close device, rx will be enabled if wol is enabeld. When open device it will cause rx to dma to wrong address after pci_set_master().

In this patch, driver will disable tx/rx when close device. If wol is eanbled only enable rx filter and disable rxdv_gate to let hardware can receive packet to fifo but not to dma it.

---
v1 -> v2: limit the call to rtl_disable_rxdvgate()

Ah, I didn't notice there was a v2, same comments as for v1:
looks like a fix..