thermal/governors: Fix cooling device setting cooling state failure
Subsystems (2)
PATCH 2/2 thermal/governors: Fix cooling device setting cooling state failure
Because the __thermal_cdev_update function traverses the cooling_device->thermal_instances list to obtain the maximum target state, and then the cooling device sets the maximum cooling state. However, the power_actor_set_power function only updates the target value of thermal_zone->thermal_instances to the target state, and does not update the target value of cooling_device->thermal_instances, resulting in the target being 0 all the time.
Signed-off-by Qibo Huang <[email protected]>
--- drivers/thermal/gov_power_allocator.c | 6 ++++++ 1 file changed, 6 insertions(+)
drivers/thermal/gov_power_allocator.c +6 -0
@@ -293,6 +293,7 @@ power_actor_set_power(struct thermal_cooling_device *cdev, struct thermal_instance *instance, u32 power) {unsigned long state; +struct thermal_instance *cdev_instance;int ret; ret = cdev->ops->power2state (cdev, power, &state);
@@ -300,6 +301,11 @@ power_actor_set_power(struct thermal_cooling_device *cdev,return ret; instance->target =clamp_val (state, instance->lower, instance->upper); +list_for_each_entry (cdev_instance, &cdev->thermal_instances, cdev_node){ +if (cdev_instance->tz->id == instance->tz->id){ + cdev_instance->target = state; + } + }mutex_lock (&cdev->lock);__thermal_cdev_update (cdev);mutex_unlock (&cdev->lock);
Signature · 1 line
2.37.1