drivers: fpga: Add FPGA configuration during bootm for Intel SOCFPGA
PATCH 1/1 drivers: fpga: Add FPGA configuration during bootm for Intel SOCFPGA
From: Yau Wai Gan <[email protected]>
This enable the capability to automatically perform FPGA configuration when booting Linux FIT image via bootm command. The FPGA configuration bitstream shall be packed within the FIT image.
Signed-off-by Yau Wai Gan <[email protected]>
Signed-off-by Jit Loon Lim <[email protected]>
--- drivers/fpga/altera.c | 41 +++++++++++++++++++++++++++++++++++++++++ 1 file changed, 41 insertions(+)
drivers/fpga/altera.c +41 -0
@@ -10,6 +10,10 @@/* * Altera FPGA support */ +#if IS_ENABLED (CONFIG_TARGET_SOCFPGA_AGILEX ) || \ +IS_ENABLED (CONFIG_TARGET_SOCFPGA_STRATIX10 ) +#include <asm/arch/misc.h> +#endif #include <common.h> #include <errno.h> #include <ACEX1K.h>
@@ -49,6 +53,43 @@ static const struct altera_fpga {#endif }; +#if IS_ENABLED (CONFIG_TARGET_SOCFPGA_AGILEX ) || \ +IS_ENABLED (CONFIG_TARGET_SOCFPGA_STRATIX10 ) +int fpga_is_partial_data (int devnum,size_t img_len) +{ +/* +* The FPGA data (full or partial) is checked by +* the SDM hardware, for Intel SDM Mailbox based +* devices. Hence always return full bitstream. +* +* For Cyclone V and Arria 10 family, the bitstream +* type paramater is not handled by the driver. +*/ +return 0 ; +} + +int fpga_loadbitstream (int devnum,char *fpgadata,size_t size, +bitstream_type bstype) +{ +int ret_val; +int flags =0 ; + + ret_val =fpga_load (devnum, (void *)fpgadata, size, bstype, flags); + +/* +* Enable the HPS to FPGA bridges when FPGA load is completed +* successfully. This is to ensure the FPGA is accessible +* by the HPS. +*/ +if (!ret_val) { +printf ("Enable FPGA bridges\n" ); +do_bridge_reset (1 , ~0 ); + } + +return ret_val; +} +#endif +static int altera_validate (Altera_desc *desc,const char *fn) {if (!desc) {
Signature · 1 line
2.26.2