docs-admin-guide-mm-damon-usage-fix-wrong-usage-example-of-init_regions-file.patch removed from -mm tree
The quilt patch titled
Subject: Docs/admin-guide/mm/damon/usage: fix wrong usage example of init_regions file
has been removed from the -mm tree. Its filename was
docs-admin-guide-mm-damon-usage-fix-wrong-usage-example-of-init_regions-file.patch
This patch was dropped because it was merged into the mm-stable branch of git://git.kernel.org/pub/scm/linux/kernel/git/akpm/mm
------------------------------------------------------
From: SeongJae Park <[email protected]>
Subject: Docs/admin-guide/mm/damon/usage: fix wrong usage example of init_regions file
Date: Mon, 24 Oct 2022 17:46:19 +0000
DAMON debugfs interface assumes the users will write all inputs at once. However, redirecting a string of multiple lines sometimes end up writing line by line. Therefore, the example usage of 'init_regions' file, which writes input as a string of multiple lines can fail. Fix it to use a single line string instead. Also update the description of the usage to not assume users will write inputs in multiple lines.
---
Documentation/admin-guide/mm/damon/usage.rst | 11 ++++++----- 1 file changed, 6 insertions(+), 5 deletions(-)
Documentation/admin-guide/mm/damon/usage.rst renamed from Documentation/admin-guide/mm/damon/usage.rst~docs-admin-guide-mm-damon-usage-fix-wrong-usage-example-of-init_regions-file +6 -5
@@ -468,8 +468,9 @@ regions in case of physical memory monit monitoring target regions by themselves. In such cases, users can explicitly set the initial monitoring target regions -as they want, by writing proper values to the ``init_regions`` file. Each line -of the input should represent one region in below form.:: +as they want, by writing proper values to the ``init_regions`` file. The input +should be a sequence of three integers separated by white spaces that represent +one region in below form.:: <target idx> <start address> <end address>
@@ -484,9 +485,9 @@ ranges, ``20-40`` and ``50-100`` as that # cd <debugfs>/damon # cat target_ids 42 4242 - # echo "0 1 100 - 0 100 200 - 1 20 40 + # echo "0 1 100 \ + 0 100 200 \ + 1 20 40 \ 1 50 100" > init_regions Note that this sets the initial monitoring target regions only. In case of
_
Patches currently in -mm which might be from [email protected] are