Skip to contentSkip to conversation

arm64: dts: imx8mm-beacon: Fix ecspi2 pinmux

PATCH Applied Adam Ford 2 participants 2 messages Dec 2, 2022 – Dec 31, 2022

Subsystems (2)
lore
Share & tools
lore

Adam Ford

author
#0 lore raw

PATCH 1/1 arm64: dts: imx8mm-beacon: Fix ecspi2 pinmux

Early hardware did not support hardware handshaking on the UART, but final production hardware did. When the hardware was updated the chip select was changed to facilitate hardware handshaking on UART3. Fix the ecspi2 pin mux to eliminate a pin conflict with UART3 and allow the EEPROM to operate again.

Fixes 4ce01ce36d77 ("arm64: dts: imx8mm-beacon: Enable RTS-CTS on UART3")
arch/arm64/boot/dts/freescale/imx8mm-beacon-baseboard.dtsi +2 -2
index 03266bd90a06..169f047fbca5 100644
@@ -120,7 +120,7 @@ &csi {
 &ecspi2 {
 	pinctrl-names = "default";
 	pinctrl-0 = <&pinctrl_espi2>;
-	cs-gpios = <&gpio5 9 GPIO_ACTIVE_LOW>;
+	cs-gpios = <&gpio5 13 GPIO_ACTIVE_LOW>;
 	status = "okay";
 
 	eeprom@0 {
@@ -316,7 +316,7 @@ pinctrl_espi2: espi2grp {
 			MX8MM_IOMUXC_ECSPI2_SCLK_ECSPI2_SCLK		0x82
 			MX8MM_IOMUXC_ECSPI2_MOSI_ECSPI2_MOSI		0x82
 			MX8MM_IOMUXC_ECSPI2_MISO_ECSPI2_MISO		0x82
-			MX8MM_IOMUXC_ECSPI1_SS0_GPIO5_IO9		0x41
+			MX8MM_IOMUXC_ECSPI2_SS0_GPIO5_IO13              0x41
 		>;
 	};
 
Signature · 1 line
2.34.1
Applied
#1 lore raw
Quoted 8 lines · Adam Ford

Early hardware did not support hardware handshaking on the UART, but final production hardware did. When the hardware was updated the chip select was changed to facilitate hardware handshaking on UART3. Fix the ecspi2 pin mux to eliminate a pin conflict with UART3 and allow the EEPROM to operate again.

Fixes 4ce01ce36d77 ("arm64: dts: imx8mm-beacon: Enable RTS-CTS on UART3")

Applied, thanks!