nvme-apple: Add NVME_QUIRK_IDENTIFY_CNS quirk to fix regression
Subsystems (2)
PATCH 1/1 nvme-apple: Add NVME_QUIRK_IDENTIFY_CNS quirk to fix regression
From the get-go, this driver and the ANS syslog have been complaining about namespace identification. In 6.2-rc1, commit 811f4de0344d ("nvme:
avoid fallback to sequential scan due to transient issues") regressed the driver by no longer allowing fallback to sequential namespace scans, leaving us with no namespaces.
It turns out that the real problem is that this controller claiming NVMe 1.1 compat is treating the CNS field as a binary field, as in NVMe 1.0. This already has a quirk, NVME_QUIRK_IDENTIFY_CNS, so set it for the controller to fix all this nonsense (including other errors triggered by other CNS commands).
--- drivers/nvme/host/apple.c | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)
drivers/nvme/host/apple.c +1 -1
@@ -1553,7 +1553,7 @@ static int apple_nvme_probe(struct platform_device *pdev) } ret =nvme_init_ctrl (&anv->ctrl, anv->dev, &nvme_ctrl_ops, -NVME_QUIRK_SKIP_CID_GEN ); +NVME_QUIRK_SKIP_CID_GEN |NVME_QUIRK_IDENTIFY_CNS );if (ret) {dev_err_probe (dev, ret,"Failed to initialize nvme_ctrl" ); goto put_dev;
--
2.35.1
Hi,
Quoted 12 lines · Hector Martin
From the get-go, this driver and the ANS syslog have been complaining about namespace identification. In 6.2-rc1, commit
811f4de0344d("nvme:
avoid fallback to sequential scan due to transient issues") regressed the driver by no longer allowing fallback to sequential namespace scans, leaving us with no namespaces.It turns out that the real problem is that this controller claiming NVMe 1.1 compat is treating the CNS field as a binary field, as in NVMe 1.0. This already has a quirk,
NVME_QUIRK_IDENTIFY_CNS, so set it for the controller to fix all this nonsense (including other errors triggered by other CNS commands).
Quoted 4 lines
Fixes 811f4de0344d ("nvme: avoid fallback to sequential scan due totransient issues")
Fixes 5bd2927aceba ("nvme-apple: Add initial Apple SoC NVMe driver")Signed-off-by Hector Martin <[email protected]>
Nice, I've been meaning to look into those weird namespace scanning errors for a while now but never got around to it because they didn't break anything.
There's a chance this is also required for the later T2/x86 Macs in pci.c (PCI_DEVICE(PCI_VENDOR_ID_APPLE, 0x2005)) since they share a similar firmware but I don't have access to those to test if this is actually required.
Best,
Sven
PATCH 1/1 nvme-pci: Add NVME_QUIRK_IDENTIFY_CNS quirk to Apple T2 controllers
In reply to Hector MartinThis mirrors the quirk added to Apple Silicon controllers in apple.c. These controllers do not support the Active NS ID List command and behave identically to the SoC version judging by existing user reports/syslogs, so will need the same fix. This quirk reverts back to NVMe 1.0 behavior and disables the broken commands.
--- drivers/nvme/host/pci.c | 3 ++- 1 file changed, 2 insertions(+), 1 deletion(-)
Note: this is untested (since probably nobody with a T2 is running 6.2 RCs yet), but given that these controllers share the same firmware codebase and some other quirks, it is almost certain they regressed just like the M1/M2 controllers did. Existing syslogs from T2 machines show the same errors we were getting on M1/M2 prior to the regression, which points to them having the same issue of treating CNS as a binary flag as in NVMe 1.0 all along.
Sven has asked some of the T2 folks if they can test a 6.2 RC to verify the same regression happened, so hopefully we can get confirmation that this needs fixing (and the fix works), but if we end up getting no feedback I'd lean towards just getting this applied as a fix since it's unlikely to break anything and highly likely to fix a regression.
drivers/nvme/host/pci.c +2 -1
@@ -3495,7 +3495,8 @@ static const struct pci_device_id nvme_id_table[] = { .driver_data = NVME_QUIRK_SINGLE_VECTOR | NVME_QUIRK_128_BYTES_SQES | NVME_QUIRK_SHARED_TAGS | - NVME_QUIRK_SKIP_CID_GEN }, + NVME_QUIRK_SKIP_CID_GEN | + NVME_QUIRK_IDENTIFY_CNS }, { PCI_DEVICE_CLASS(PCI_CLASS_STORAGE_EXPRESS, 0xffffff) }, { 0, } };
--
2.35.1
Re: [PATCH] nvme-pci: Add NVME_QUIRK_IDENTIFY_CNS quirk to Apple T2 controllers
Quoted 8 lines
This mirrors the quirk added to Apple Silicon controllers in
apple.c. These controllers do not support the Active NS ID List command and behave identically to the SoC version judging by existing user reports/syslogs, so will need the same fix. This quirk reverts back to NVMe 1.0 behavior and disables the broken commands.Fixes 811f4de0344d ("nvme: avoid fallback to sequential scan due to transient issues")Signed-off-by Hector Martin <[email protected]>
On T2 macbookpro16,1 with 6.2.0-rc3-00010-g69b41ac87e4a I had this in dmesg:
nvme nvme0: 1/0/0 default/read/poll queues
nvme nvme0: Identify NS List failed (status=0xb)
And in /dev only nvme0 existed (no nvme0n1*).
This patch fixed that and /dev/nvme0n1p* existed.
Thanks,
I've applied both patches to nvme-6.2.