Skip to contentSkip to conversation

usb: gadget: dwc2_udc_otg: implement pullup()

PATCH New Mattijs Korpershoek 1 participant 1 message Jan 11, 2023 USB

lore
Share & tools
lore
#0 lore raw

PATCH v3 1/1 usb: gadget: dwc2_udc_otg: implement pullup()

Pullup is used by the usb framework in order to do software-controlled usb_gadget_connect() and usb_gadget_disconnect().

Implement pullup() for dwc2 using the SOFT_DISCONNECT bit in the dctl register:
* when pullup is on, clear SOFT_DISCONNECT
* when pullup is off, set SOFT_DISCONNECT

This is especially useful when a gadget disconnection is initiated but no board_usb_cleanup() is called.

---
On some boards using the dwc2 controller, like the Khadas VIM3L, whenever usb_gadget_release() is called, the D+ and D- lines are in an unknown state.

Because of that, the host can't detect usb disconnection.

It was attempted to be be fixed with [1] but ended up doing the gadget disconnection too early, creating issues on NXP-based boards which use uuu [2].

By implementing pullup() in the controller driver, we ensure that the disconnection will only be done when the framework calls usb_gadget_disconnect().

[1] https://lore.kernel.org/all/[email protected]/
[2] https://lore.kernel.org/all/[email protected]/
---
Changes in v3:
- Simplified even further usage of clrsetbits_le32 (Marek)
- Link to v2: https://lore.kernel.org/r/[email protected]

Changes in v2:
- Simplified code to fix hungarian notation, appropriate type (u32) for register (Harald)
- Use clrsetbits_le32() for register write (Marek)
- Link to v1: https://lore.kernel.org/r/[email protected]

---
 drivers/usb/gadget/dwc2_udc_otg.c | 9 +++++++++
 1 file changed, 9 insertions(+)
drivers/usb/gadget/dwc2_udc_otg.c +9 -0
index 77988f78ab30..2bf7ed8d6046 100644
@@ -236,6 +236,14 @@ static int udc_enable(struct dwc2_udc *dev)
 	return 0;
 }
 
+static int dwc2_gadget_pullup(struct usb_gadget *g, int is_on)
+{
+	clrsetbits_le32(&reg->dctl, SOFT_DISCONNECT,
+			is_on ? 0 : SOFT_DISCONNECT);
+
+	return 0;
+}
+
 #if !CONFIG_IS_ENABLED(DM_USB_GADGET)
 /*
   Register entry point for the peripheral controller driver.
@@ -805,6 +813,7 @@ static void dwc2_fifo_flush(struct usb_ep *_ep)
 }
 
 static const struct usb_gadget_ops dwc2_udc_ops = {
+	.pullup = dwc2_gadget_pullup,
 	/* current versions must always be self-powered */
 #if CONFIG_IS_ENABLED(DM_USB_GADGET)
 	.udc_start		= dwc2_gadget_start,

---
base-commit: 81996adedf42e89de97c2ed5dcde62be4bb4e4e0
change-id: 20230110-dwc2-pullup-5b0f5a073d6b

Best regards,

Signature · 1 line
Mattijs Korpershoek <[email protected]>