armv7: ls102xa: make QSPI clock selection optional during SoC init
PATCH 1/1 armv7: ls102xa: make QSPI clock selection optional during SoC init
To improve startup times when booting from QSPI flash, the QSPI frequency can be configured very early in the boot process [1] to reduce loading times of U-Boot itself. This patch adds an option to disable setting the frequency to a default value during SoC initialization.
[1] https://www.nxp.com/docs/en/application-note/AN12279.pdf
Signed-off-by Mario Kicherer <[email protected]>
--- arch/arm/cpu/armv7/ls102xa/Kconfig | 9 +++++++++ arch/arm/cpu/armv7/ls102xa/soc.c | 4 ++-- 2 files changed, 11 insertions(+), 2 deletions(-)
arch/arm/cpu/armv7/ls102xa/Kconfig +9 -0
@@ -98,4 +98,13 @@ config SYS_FSL_IFC_BANK_COUNT config SYS_FSL_ERRATUM_A008407 bool +config SYS_FSL_QSPI_SKIP_CLKSEL + bool "Skip setting QSPI clock during SoC init" + default 0 + help + To improve startup times when booting from QSPI flash, the QSPI + frequency can be set very early in the boot process. If this option + is enabled, the QSPI frequency will not be changed by U-Boot during + SoC initialization. + endmenu
arch/arm/cpu/armv7/ls102xa/soc.c +2 -2
@@ -169,8 +169,8 @@ int arch_soc_init(void)#ifdef CONFIG_LAYERSCAPE_NS_ACCESS enable_layerscape_ns_access ();#endif - -#if defined(CONFIG_FSL_QSPI ) + +#if defined(CONFIG_FSL_QSPI ) && !defined(CONFIG_SYS_FSL_QSPI_SKIP_CLKSEL )out_be32 (&scfg->qspi_cfg,SCFG_QSPI_CLKSEL );#endif
Signature · 1 line
2.34.1