Skip to contentSkip to conversation

arm64: dts: add pinctrl-single property for Stratix10/Agilex

PATCH New Dinh Nguyen 1 participant 2 messages Jan 23, 2023

Subsystems (2)
lore
Share & tools
lore

Dinh Nguyen

author maintainer
#0 lore raw

PATCH v2 1/2 arm64: dts: add pinctrl-single property for Stratix10/Agilex

The Stratix10/Agilex has a pin control IP that can make use of the pinctrl-single driver.

Add the pinctrl-single dts property for the Stratix10/Agilex platforms.

---
v2: no changes

---
 .../arm64/boot/dts/altera/socfpga_stratix10.dtsi | 16 ++++++++++++++++
 arch/arm64/boot/dts/intel/socfpga_agilex.dtsi    | 15 +++++++++++++++
 2 files changed, 31 insertions(+)
arch/arm64/boot/dts/altera/socfpga_stratix10.dtsi +16 -0
index 55c5e1fdddc7..b488e8d185f3 100644
@@ -353,6 +353,22 @@ pdma: dma-controller@ffda0000 {
 			reset-names = "dma", "dma-ocp";
 		};
 
+		pinctrl0: pinctrl@ffd13000 {
+			compatible = "pinctrl-single";
+			reg = <0xffd13000 0xA0>;
+			#pinctrl-cells = <1>;
+			pinctrl-single,register-width = <32>;
+			pinctrl-single,function-mask = <0x0000000f>;
+		};
+
+		pinctrl1: pinctrl@ffd13100 {
+			compatible = "pinctrl-single";
+			reg = <0xffd13100 0x20>;
+			#pinctrl-cells = <1>;
+			pinctrl-single,register-width = <32>;
+			pinctrl-single,function-mask = <0x0000000f>;
+		};
+
 		rst: rstmgr@ffd11000 {
 			#reset-cells = <1>;
 			compatible = "altr,stratix10-rst-mgr";
arch/arm64/boot/dts/intel/socfpga_agilex.dtsi +15 -0
index 849b46dd8098..f22302a19796 100644
@@ -357,6 +357,21 @@ pdma: dma-controller@ffda0000 {
 			clock-names = "apb_pclk";
 		};
 
+		pinctrl0: pinctrl@ffd13000 {
+			compatible = "pinctrl-single";
+			#pinctrl-cells = <1>;
+			reg = <0xffd13000 0xa0>;
+			pinctrl-single,register-width = <32>;
+			pinctrl-single,function-mask = <0x0000000f>;
+		};
+
+		pinctrl1: pinconf@ffd13100 {
+			compatible = "pinctrl-single";
+			#pinctrl-cells = <1>;
+			reg = <0xffd13100 0x20>;
+			pinctrl-single,register-width = <32>;
+		};
+
 		rst: rstmgr@ffd11000 {
 			#reset-cells = <1>;
 			compatible = "altr,stratix10-rst-mgr";
Signature · 1 line
2.25.1
author maintainer
#1 lore raw

PATCH v2 2/2 arm64: dts: stratix10: add i2c pins for pinctrl

Add the I2C pins definition to the Stratix10 devkit. This allows for the I2C driver to use pinctrl on the pins to allow for GPIO recovery.

---
v2: remove underscores in node names

---
 .../dts/altera/socfpga_stratix10_socdk.dts    | 23 +++++++++++++++++++
 1 file changed, 23 insertions(+)
arch/arm64/boot/dts/altera/socfpga_stratix10_socdk.dts +23 -0
index 17752ca743e5..38ae674f2f02 100644
@@ -65,6 +65,22 @@ sdmmca-ecc@ff8c8c00 {
 	};
 };
 
+&pinctrl0 {
+	i2c1_pmx_func: i2c1-pmx-func {
+		pinctrl-single,pins = <
+			0x78   0x4   /* I2C1_SDA (IO6-B) PIN30SEL) */
+			0x7c   0x4   /* I2C1_SCL (IO7-B) PIN31SEL */
+		>;
+	};
+
+	i2c1_pmx_func_gpio: i2c1-pmx-func-gpio {
+		pinctrl-single,pins = <
+			0x78   0x8   /* I2C1_SDA (IO6-B) PIN30SEL) */
+			0x7c   0x8   /* I2C1_SCL (IO7-B) PIN31SEL */
+		>;
+	};
+};
+
 &gpio1 {
 	status = "okay";
 };
@@ -131,6 +147,13 @@ &i2c1 {
 	i2c-sda-falling-time-ns = <890>;  /* hcnt */
 	i2c-sdl-falling-time-ns = <890>;  /* lcnt */
 
+	pinctrl-names = "default", "gpio";
+	pinctrl-0 = <&i2c1_pmx_func>;
+	pinctrl-1 = <&i2c1_pmx_func_gpio>;
+
+	scl-gpios = <&portb 6 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>;
+	sda-gpios = <&portb 7 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>;
+
 	adc@14 {
 		compatible = "lltc,ltc2497";
 		reg = <0x14>;
Signature · 1 line
2.25.1