Skip to contentSkip to conversation

hwmon: (aquacomputer_d5next) Add support for Aquacomputer Poweradjust 3

PATCH Applied Aleksa Savic 2 participants 2 messages Jan 31, 2023

Subsystems (3)
lore
Share & tools
lore

Aleksa Savic

author maintainer
#0 lore raw

PATCH 1/1 hwmon: (aquacomputer_d5next) Add support for Aquacomputer Poweradjust 3

Extend aquacomputer_d5next driver to expose the temp sensor of the Aquacomputer Poweradjust 3 fan controller, which communicates through a proprietary USB HID protocol.

The Poweradjust 3 is not currently known to expose firmware version and serial number, so don't create debugfs entries if their values can't be retrieved.

Tested by a user on Github [1].

[1] https://github.com/aleksamagicka/aquacomputer_d5next-hwmon/issues/57

---
 Documentation/hwmon/aquacomputer_d5next.rst |  3 +
 drivers/hwmon/aquacomputer_d5next.c         | 88 +++++++++++++++++++--
 2 files changed, 84 insertions(+), 7 deletions(-)
Documentation/hwmon/aquacomputer_d5next.rst +3 -0
index 3f7880fb8116..527bcd3edda9 100644
@@ -12,6 +12,7 @@ Supported devices:
 * Aquacomputer Octo fan controller
 * Aquacomputer Quadro fan controller
 * Aquacomputer High Flow Next sensor
+* Aquacomputer Poweradjust 3 fan controller
 
 Author: Aleksa Savic
 
@@ -53,6 +54,8 @@ The High Flow Next exposes +5V voltages, water quality, conductivity and flow re
 A temperature sensor can be connected to it, in which case it provides its reading
 and an estimation of the dissipated/absorbed power in the liquid cooling loop.
 
+The Poweradjust 3 controller exposes a single external temperature sensor.
+
 Depending on the device, not all sysfs and debugfs entries will be available.
 Writing to virtual temperature sensors is not currently supported.
 
drivers/hwmon/aquacomputer_d5next.c +81 -7

168 lines not on this page · raw message

Signature · 1 line
2.39.1
maintainer Applied
#1 lore raw
Quoted 8 lines · Aleksa Savic

Extend aquacomputer_d5next driver to expose the temp sensor of the Aquacomputer Poweradjust 3 fan controller, which communicates through a proprietary USB HID protocol.

The Poweradjust 3 is not currently known to expose firmware version and serial number, so don't create debugfs entries if their values can't be retrieved.

Quoted 5 lines

Tested by a user on Github [1].

[1] https://github.com/aleksamagicka/aquacomputer_d5next-hwmon/issues/57

Applied to hwmon-next.

Thanks,
Guenter