Skip to contentSkip to conversation

hid-mcp2200: added driver for GPIOs of MCP2200

PATCH New Johannes Roith 1 participant 1 message Jun 15, 2023 HID

lore
Share & tools
lore
#0 lore raw

PATCH 1/1 hid-mcp2200: added driver for GPIOs of MCP2200

Added a gpiochip compatible driver to control the 8 GPIOs of the MCP2200 by using the HID interface.

Using GPIOs with alternative functions (GP0<->SSPND, GP1<->USBCFG, GP6<->RXLED, GP7<->TXLED) will reset the functions, if set (unset by default).

The driver was tested while also using the UART of the chip. Setting and reading the GPIOs has no effect on the UART communication. However, a reset is triggered after the CONFIGURE command. If the GPIO Direction is constantly changed, this will affect the communication at low baud rates. This is a hardware problem of the MCP2200 and is not caused by the driver.

Feedback from reviewers Christophe JAILLET <[email protected]> and Andi Shyti <[email protected]> was added.

---
 drivers/hid/Kconfig       |  10 +
 drivers/hid/Makefile      |   1 +
 drivers/hid/hid-ids.h     |   1 +
 drivers/hid/hid-mcp2200.c | 416 ++++++++++++++++++++++++++++++++++++++
 4 files changed, 428 insertions(+)
 create mode 100644 drivers/hid/hid-mcp2200.c
drivers/hid/Kconfig +10 -0
index 4ce012f83253..ca7927d22c23 100644
@@ -1283,6 +1283,16 @@ config HID_MCP2221
 	To compile this driver as a module, choose M here: the module
 	will be called hid-mcp2221.ko.
 
+config HID_MCP2200
+   tristate "Microchip MCP2200 HID USB-to-GPIO bridge"
+   depends on USB_HID
+   imply GPIOLIB
+   help
+   Provides GPIO functionality over USB-HID through MCP2200 device.
+
+   To compile this driver as a module, choose M here: the module
+   will be called hid-mcp2200.ko.
+
 config HID_KUNIT_TEST
 	tristate "KUnit tests for HID" if !KUNIT_ALL_TESTS
 	depends on KUNIT=y
drivers/hid/Makefile +1 -0
index 5d37cacbde33..d593fb982f7d 100644
@@ -79,6 +79,7 @@ obj-$(CONFIG_HID_MACALLY)	+= hid-macally.o
 obj-$(CONFIG_HID_MAGICMOUSE)	+= hid-magicmouse.o
 obj-$(CONFIG_HID_MALTRON)	+= hid-maltron.o
 obj-$(CONFIG_HID_MCP2221)	+= hid-mcp2221.o
+obj-$(CONFIG_HID_MCP2200)	+= hid-mcp2200.o
 obj-$(CONFIG_HID_MAYFLASH)	+= hid-mf.o
 obj-$(CONFIG_HID_MEGAWORLD_FF)	+= hid-megaworld.o
 obj-$(CONFIG_HID_MICROSOFT)	+= hid-microsoft.o
drivers/hid/hid-ids.h +1 -0
index 5d29abac2300..017e37a171a8 100644
@@ -912,6 +912,7 @@
 #define USB_DEVICE_ID_PICK16F1454_V2	0xf2f7
 #define USB_DEVICE_ID_LUXAFOR		0xf372
 #define USB_DEVICE_ID_MCP2221		0x00dd
+#define USB_DEVICE_ID_MCP2200		0x00df
 
 #define USB_VENDOR_ID_MICROSOFT		0x045e
 #define USB_DEVICE_ID_SIDEWINDER_GV	0x003b
drivers/hid/hid-mcp2200.c new file +416 -0

416 lines not on this page · raw message

+

Signature · 1 line
2.41.0