arm: mach-k3: am62a7_init: Open up FSS_DAT_REG3 firewall
Subsystems (2)
PATCH 1/1 arm: mach-k3: am62a7_init: Open up FSS_DAT_REG3 firewall
On security enforced (HS-SE) devices ROM firewalls OSPI data region3 that is present in above 64bit region. Open this up in bootloader to allow Linux to access OSPI flashes in mmap mode.
Without this kernel will crash when accessing this region due to firewall violations on HS-SE devices.
Signed-off-by Vignesh Raghavendra <[email protected]>
--- arch/arm/mach-k3/am62a7_init.c | 7 +++++++ 1 file changed, 7 insertions(+)
arch/arm/mach-k3/am62a7_init.c +7 -0
@@ -14,6 +14,10 @@#include <dm/uclass-internal.h> #include <dm/pinctrl.h> +struct fwl_data cbass_main_fwls[] = { + {"FSS_DAT_REG3" ,7 ,8 }, +}; +/* * This uninitialized global variable would normal end up in the .bss section, * but the .bss is cleared between writing and reading this variable, so move
@@ -166,6 +170,9 @@ void board_init_f(ulong dummy)/* Output System Firmware version info */ k3_sysfw_print_ver (); +/* Disable ROM configured firewalls right after loading sysfw */ +remove_fwl_configs (cbass_main_fwls,ARRAY_SIZE (cbass_main_fwls)); +#if defined(CONFIG_K3_AM62A_DDRSS ) ret =uclass_get_device (UCLASS_RAM ,0 , &dev);if (ret)
Signature · 1 line
2.40.1
Quoted 8 lines · Vignesh Raghavendra
On security enforced (HS-SE) devices ROM firewalls OSPI data region3 that is present in above 64bit region. Open this up in bootloader to allow Linux to access OSPI flashes in mmap mode.
Without this kernel will crash when accessing this region due to firewall violations on HS-SE devices.
Signed-off-by Vignesh Raghavendra <[email protected]>
Applied to u-boot/master, thanks!
Signature · 1 line
Tom