ARM: dts: st: dts fixes in stih418-b2264.dts
Subsystems (2)
cover ARM: dts: st: dts fixes in stih418-b2264.dts
Correction of two dts warnings and led state in stih418-b2264.dts
Alain Volmat (3):
ARM: dts: st: correct serial alias in stih418-b2264.dts
ARM: dts: st: move leds out of soc in stih418-b2264.dts
ARM: dts: st: correct led level in stih418-b2264.dts
arch/arm/boot/dts/st/stih418-b2264.dts | 16 ++++++++-------- 1 file changed, 8 insertions(+), 8 deletions(-)
Signature · 7 lines
2.34.1 _______________________________________________ linux-arm-kernel mailing list [email protected] http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
PATCH 1/3 ARM: dts: st: correct serial alias in stih418-b2264.dts
Aliases should only contain lowercase, digits or - hence correct the alias for the serial from ttyAS0 into serial0 as already done for the other boards.
--- arch/arm/boot/dts/st/stih418-b2264.dts | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)
arch/arm/boot/dts/st/stih418-b2264.dts +1 -1
@@ -69,7 +69,7 @@ opp04 { }; aliases { - ttyAS0 = &sbc_serial0; + serial0 = &sbc_serial0; ethernet0 = ðernet0; };
Signature · 7 lines
2.34.1 _______________________________________________ linux-arm-kernel mailing list [email protected] http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
Re: [PATCH 1/3] ARM: dts: st: correct serial alias in stih418-b2264.dts
Quoted 14 lines · Alain Volmat
Aliases should only contain lowercase, digits or - hence correct the alias for the serial from ttyAS0 into serial0 as already done for the other boards.
Signed-off-by Alain Volmat <[email protected]>--- arch/arm/boot/dts/st/stih418-b2264.dts | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)arch/arm/boot/dts/st/stih418-b2264.dts +0
-0
arch/arm/boot/dts/st/stih418-b2264.dts opp04 { · line 75
Quoted 8 lines
arch/arm/boot/dts/st/stih418-b2264.dts +1
-1@@ -69,7 +69,7 @@ opp04 { }; aliases { - ttyAS0 = &sbc_serial0; + serial0 = &sbc_serial0; ethernet0 = ðernet0; };
Thanks
Patrice
_______________________________________________
linux-arm-kernel mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
Patrice CHOTARD
maintainerRe: [PATCH 1/3] ARM: dts: st: correct serial alias in stih418-b2264.dts
In reply to Alain VolmatQuoted 14 lines · Alain Volmat
Aliases should only contain lowercase, digits or - hence correct the alias for the serial from ttyAS0 into serial0 as already done for the other boards.
Signed-off-by Alain Volmat <[email protected]>--- arch/arm/boot/dts/st/stih418-b2264.dts | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)arch/arm/boot/dts/st/stih418-b2264.dts +0
-0
arch/arm/boot/dts/st/stih418-b2264.dts opp04 { · line 75
Quoted 8 lines
arch/arm/boot/dts/st/stih418-b2264.dts +1
-1@@ -69,7 +69,7 @@ opp04 { }; aliases { - ttyAS0 = &sbc_serial0; + serial0 = &sbc_serial0; ethernet0 = ðernet0; };
Applied on sti-next
Thanks
Patrice
_______________________________________________
linux-arm-kernel mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
PATCH 2/3 ARM: dts: st: move leds out of soc in stih418-b2264.dts
In reply to Alain VolmatMove the leds node out of the soc section
and correct the following warning:
Warning (simple_bus_reg): /soc/leds: missing or empty reg/ranges property
--- arch/arm/boot/dts/st/stih418-b2264.dts | 14 +++++++------- 1 file changed, 7 insertions(+), 7 deletions(-)
arch/arm/boot/dts/st/stih418-b2264.dts +7 -7
@@ -73,15 +73,15 @@ aliases { ethernet0 = ðernet0; }; - soc { - leds { - compatible = "gpio-leds"; - led-green { - gpios = <&pio1 3 GPIO_ACTIVE_HIGH>; - default-state = "off"; - }; + leds { + compatible = "gpio-leds"; + led-green { + gpios = <&pio1 3 GPIO_ACTIVE_HIGH>; + default-state = "off"; }; + }; + soc { pin-controller-sbc@961f080 { gmac1 { rgmii1-0 {
Signature · 7 lines
2.34.1 _______________________________________________ linux-arm-kernel mailing list [email protected] http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
Re: [PATCH 2/3] ARM: dts: st: move leds out of soc in stih418-b2264.dts
Quoted 26 lines · Alain Volmat
Move the leds node out of the soc section
and correct the following warning:
Warning (simple_bus_reg): /soc/leds: missing or empty reg/ranges propertySigned-off-by Alain Volmat <[email protected]>--- arch/arm/boot/dts/st/stih418-b2264.dts | 14 +++++++------- 1 file changed, 7 insertions(+), 7 deletions(-)arch/arm/boot/dts/st/stih418-b2264.dts +2
-7@@ -73,15 +73,15 @@ aliases { ethernet0 = ðernet0; }; - soc { - leds { - compatible = "gpio-leds"; - led-green { - gpios = <&pio1 3 GPIO_ACTIVE_HIGH>; - default-state = "off"; - }; + leds { + compatible = "gpio-leds";
arch/arm/boot/dts/st/stih418-b2264.dts aliases { · line 87
Quoted 10 lines
arch/arm/boot/dts/st/stih418-b2264.dts +5
-0+ led-green { + gpios = <&pio1 3 GPIO_ACTIVE_HIGH>; + default-state = "off"; }; + }; + soc { pin-controller-sbc@961f080 { gmac1 { rgmii1-0 {
Thanks
PAtrice
_______________________________________________
linux-arm-kernel mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
Patrice CHOTARD
maintainerRe: [PATCH 2/3] ARM: dts: st: move leds out of soc in stih418-b2264.dts
In reply to Alain VolmatQuoted 26 lines · Alain Volmat
Move the leds node out of the soc section
and correct the following warning:
Warning (simple_bus_reg): /soc/leds: missing or empty reg/ranges propertySigned-off-by Alain Volmat <[email protected]>--- arch/arm/boot/dts/st/stih418-b2264.dts | 14 +++++++------- 1 file changed, 7 insertions(+), 7 deletions(-)arch/arm/boot/dts/st/stih418-b2264.dts +2
-7@@ -73,15 +73,15 @@ aliases { ethernet0 = ðernet0; }; - soc { - leds { - compatible = "gpio-leds"; - led-green { - gpios = <&pio1 3 GPIO_ACTIVE_HIGH>; - default-state = "off"; - }; + leds { + compatible = "gpio-leds";
arch/arm/boot/dts/st/stih418-b2264.dts aliases { · line 87
Quoted 10 lines
arch/arm/boot/dts/st/stih418-b2264.dts +5
-0+ led-green { + gpios = <&pio1 3 GPIO_ACTIVE_HIGH>; + default-state = "off"; }; + }; + soc { pin-controller-sbc@961f080 { gmac1 { rgmii1-0 {
Applied on sti-next
Thanks
Patrice
_______________________________________________
linux-arm-kernel mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
Patrice CHOTARD
maintainerRe: [PATCH 2/3] ARM: dts: st: move leds out of soc in stih418-b2264.dts
Quoted 35 lines · Patrice CHOTARD
Quoted 32 lines · Alain Volmat
Move the leds node out of the soc section
and correct the following warning:
Warning (simple_bus_reg): /soc/leds: missing or empty reg/ranges propertySigned-off-by Alain Volmat <[email protected]>--- arch/arm/boot/dts/st/stih418-b2264.dts | 14 +++++++------- 1 file changed, 7 insertions(+), 7 deletions(-)arch/arm/boot/dts/st/stih418-b2264.dts +6
-7@@ -73,15 +73,15 @@ aliases { ethernet0 = ðernet0; }; - soc { - leds { - compatible = "gpio-leds"; - led-green { - gpios = <&pio1 3 GPIO_ACTIVE_HIGH>; - default-state = "off"; - }; + leds { + compatible = "gpio-leds"; + led-green { + gpios = <&pio1 3 GPIO_ACTIVE_HIGH>; + default-state = "off"; }; + };
Quoted 8 lines
arch/arm/boot/dts/st/stih418-b2264.dts aliases { · line 87
Quoted 4 lines
arch/arm/boot/dts/st/stih418-b2264.dts +1
-0+ soc { pin-controller-sbc@961f080 { gmac1 { rgmii1-0 {Applied on sti-next
Thanks
Patrice
Applied on sti-next
Thanks
Patrice
_______________________________________________
linux-arm-kernel mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
PATCH 3/3 ARM: dts: st: correct led level in stih418-b2264.dts
In reply to Alain VolmatThe state of the green led on the stih418-b2264 is currently inverted. Correct this by fixing the GPIO active state.
--- arch/arm/boot/dts/st/stih418-b2264.dts | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)
arch/arm/boot/dts/st/stih418-b2264.dts +1 -1
@@ -76,7 +76,7 @@ aliases { leds { compatible = "gpio-leds"; led-green { - gpios = <&pio1 3 GPIO_ACTIVE_HIGH>; + gpios = <&pio1 3 GPIO_ACTIVE_LOW>; default-state = "off"; }; };
Signature · 7 lines
2.34.1 _______________________________________________ linux-arm-kernel mailing list [email protected] http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
Re: [PATCH 3/3] ARM: dts: st: correct led level in stih418-b2264.dts
Quoted 13 lines · Alain Volmat
The state of the green led on the stih418-b2264 is currently inverted. Correct this by fixing the GPIO active state.
Signed-off-by Alain Volmat <[email protected]>--- arch/arm/boot/dts/st/stih418-b2264.dts | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)arch/arm/boot/dts/st/stih418-b2264.dts +0
-0
arch/arm/boot/dts/st/stih418-b2264.dts aliases { · line 82
Quoted 8 lines
arch/arm/boot/dts/st/stih418-b2264.dts +1
-1@@ -76,7 +76,7 @@ aliases { leds { compatible = "gpio-leds"; led-green { - gpios = <&pio1 3 GPIO_ACTIVE_HIGH>; + gpios = <&pio1 3 GPIO_ACTIVE_LOW>; default-state = "off"; }; };
Thanks
Patrice
_______________________________________________
linux-arm-kernel mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel