arm: mach-k3: am62a7: change some prints to debug prints
Subsystems (2)
PATCH 1/1 arm: mach-k3: am62a7: change some prints to debug prints
There is little need to print the devstat information or when we exit a function during a typical boot. Remove them to reduce the noise during typical operation
Signed-off-by Bryan Brattlof <[email protected]>
--- arch/arm/mach-k3/am62a7_init.c | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-)
arch/arm/mach-k3/am62a7_init.c +2 -2
@@ -174,7 +174,7 @@ void board_init_f(ulong dummy)setup_qos (); -printf ("am62a_init: %s done\n" , __func__); +debug ("am62a_init: %s done\n" , __func__); }static u32 __get_backup_bootmedia (u32 devstat)
@@ -272,7 +272,7 @@ u32 spl_boot_device(void)else bootmedia =__get_backup_bootmedia (devstat); -printf ("am62a_init: %s: devstat = 0x%x bootmedia = 0x%x bootindex = %d\n" , +debug ("am62a_init: %s: devstat = 0x%x bootmedia = 0x%x bootindex = %d\n" , __func__, devstat, bootmedia, bootindex);return bootmedia; }
base-commit: 13aa090b87a0fbdfe690011669b9fdb96bb1ccc7
Signature · 1 line
2.41.0
Quoted 5 lines · Bryan Brattlof
There is little need to print the devstat information or when we exit a function during a typical boot. Remove them to reduce the noise during typical operation
Signed-off-by Bryan Brattlof <[email protected]>
Applied to u-boot/master, thanks!
Signature · 1 line
Tom