arm64: dts: imx8mm-phg: Disable flexspi
Subsystems (2)
Fabio Estevam
reviewerPATCH 1/1 arm64: dts: imx8mm-phg: Disable flexspi
From: Fabio Estevam <[email protected]>
The imx8mm-tqma8mqml SoM used on the PHG board does not come with the QSPI flash populated, so disable it to avoid the following error message:
spi-nor spi3.0: unrecognized JEDEC id bytes: 00 00 00 00 00 00
Signed-off-by Fabio Estevam <[email protected]>
--- arch/arm64/boot/dts/freescale/imx8mm-phg.dts | 5 +++++ 1 file changed, 5 insertions(+)
arch/arm64/boot/dts/freescale/imx8mm-phg.dts +5 -0
@@ -111,6 +111,11 @@ panel_out_bridge: endpoint { }; }; +/* QSPI is not populated on the SoM */ +&flexspi { + status = "disabled"; +}; + &ecspi1 { pinctrl-names = "default"; pinctrl-0 = <&pinctrl_ecspi1>;
Signature · 7 lines
2.34.1 _______________________________________________ linux-arm-kernel mailing list [email protected] http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
Shawn Guo
AppliedQuoted 9 lines · Fabio Estevam
From: Fabio Estevam <[email protected]>
The imx8mm-tqma8mqml SoM used on the PHG board does not come with the QSPI flash populated, so disable it to avoid the following error message:
spi-nor spi3.0: unrecognized JEDEC id bytes: 00 00 00 00 00 00
Signed-off-by Fabio Estevam <[email protected]>
Applied, thanks!
_______________________________________________
linux-arm-kernel mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel