Skip to contentSkip to conversation

arm-kexec-refactor-for-kernel-kconfigkexec.patch removed from -mm tree

merged mm-nonmm-stable Andrew Morton 1 participant 1 message Aug 12, 2023

lore
Share & tools
lore

Andrew Morton

author tree notice Applied
#0 lore raw

The quilt patch titled
Subject: arm/kexec: refactor for kernel/Kconfig.kexec
has been removed from the -mm tree. Its filename was
arm-kexec-refactor-for-kernel-kconfigkexec.patch

This patch was dropped because it was merged into the mm-nonmm-stable branch of git://git.kernel.org/pub/scm/linux/kernel/git/akpm/mm

------------------------------------------------------
From: Eric DeVolder <[email protected]>
Subject: arm/kexec: refactor for kernel/Kconfig.kexec
Date: Wed, 12 Jul 2023 12:15:34 -0400

The kexec and crash kernel options are provided in the common kernel/Kconfig.kexec. Utilize the common options and provide the ARCH_SUPPORTS_ and ARCH_SELECTS_ entries to recreate the equivalent set of KEXEC and CRASH options.

---

 arch/arm/Kconfig |   29 ++++-------------------------
 1 file changed, 4 insertions(+), 25 deletions(-)
arch/arm/Kconfig renamed from arch/arm/Kconfig~arm-kexec-refactor-for-kernel-kconfigkexec +4 -25
@@ -1645,20 +1645,8 @@ config XIP_DEFLATED_DATA
 	  copied, saving some precious ROM space. A possible drawback is a
 	  slightly longer boot delay.
 
-config KEXEC
-	bool "Kexec system call (EXPERIMENTAL)"
-	depends on (!SMP || PM_SLEEP_SMP)
-	depends on MMU
-	select KEXEC_CORE
-	help
-	  kexec is a system call that implements the ability to shutdown your
-	  current kernel, and to start another kernel.  It is like a reboot
-	  but it is independent of the system firmware.   And like a reboot
-	  you can start any kernel with it, not just Linux.
-
-	  It is an ongoing process to be certain the hardware in a machine
-	  is properly shutdown, so do not be surprised if this code does not
-	  initially work for you.
+config ARCH_SUPPORTS_KEXEC
+	def_bool (!SMP || PM_SLEEP_SMP) && MMU
 
 config ATAGS_PROC
 	bool "Export atags in procfs"
@@ -1668,17 +1656,8 @@ config ATAGS_PROC
 	  Should the atags used to boot the kernel be exported in an "atags"
 	  file in procfs. Useful with kexec.
 
-config CRASH_DUMP
-	bool "Build kdump crash kernel (EXPERIMENTAL)"
-	help
-	  Generate crash dump after being started by kexec. This should
-	  be normally only set in special crash dump kernels which are
-	  loaded in the main kernel with kexec-tools into a specially
-	  reserved region and then later executed after a crash by
-	  kdump/kexec. The crash dump kernel must be compiled to a
-	  memory address not used by the main kernel
-
-	  For more details see Documentation/admin-guide/kdump/kdump.rst
+config ARCH_SUPPORTS_CRASH_DUMP
+	def_bool y
 
 config AUTO_ZRELADDR
 	bool "Auto calculation of the decompressed kernel image address" if !ARCH_MULTIPLATFORM

_

Patches currently in -mm which might be from [email protected] are

crash-move-a-few-code-bits-to-setup-support-of-crash-hotplug.patch crash-add-generic-infrastructure-for-crash-hotplug-support.patch kexec-exclude-elfcorehdr-from-the-segment-digest.patch crash-memory-and-cpu-hotplug-sysfs-attributes.patch x86-crash-add-x86-crash-hotplug-support.patch crash-hotplug-support-for-kexec_load.patch crash-change-crash_prepare_elf64_headers-to-for_each_possible_cpu.patch x86-crash-optimize-cpu-changes.patch