platform/x86: int3472: Add strobe GPIO function
PATCH 1/1 platform/x86: int3472: Add strobe GPIO function
Strobe pin is used for Lattice MIPI aggregator to control the LED so it can be handled together with privacy LED.
--- drivers/platform/x86/intel/int3472/common.h | 1 + drivers/platform/x86/intel/int3472/discrete.c | 2 ++ 2 files changed, 3 insertions(+)
drivers/platform/x86/intel/int3472/common.h +1 -0
@@ -19,6 +19,7 @@/* PMIC GPIO Types */ #define INT3472_GPIO_TYPE_RESET 0x00#define INT3472_GPIO_TYPE_POWERDOWN 0x01 +#define INT3472_GPIO_TYPE_STROBE 0x02#define INT3472_GPIO_TYPE_POWER_ENABLE 0x0b#define INT3472_GPIO_TYPE_CLK_ENABLE 0x0c#define INT3472_GPIO_TYPE_PRIVACY_LED 0x0d
drivers/platform/x86/intel/int3472/discrete.c +2 -0
@@ -102,6 +102,7 @@ static void int3472_get_func_and_polarity(u8 type, const char **func, u32 *polar *func ="clk-enable" ; *polarity =GPIO_ACTIVE_HIGH ;break ; +case INT3472_GPIO_TYPE_STROBE :case INT3472_GPIO_TYPE_PRIVACY_LED : *func ="privacy-led" ; *polarity =GPIO_ACTIVE_HIGH ;
@@ -211,6 +212,7 @@ static int skl_int3472_handle_gpio_resources(struct acpi_resource *ares, err_msg ="Failed to register clock\n" ;break ; +case INT3472_GPIO_TYPE_STROBE :case INT3472_GPIO_TYPE_PRIVACY_LED : ret =skl_int3472_register_pled (int3472, agpio, polarity);if (ret)
Signature · 1 line
2.34.1
Quoted 2 lines · Hao Yao
Strobe pin is used for Lattice MIPI aggregator to control the LED so it can be handled together with privacy LED.
Thinking about this more, I am not now sure that this is a good approach. The idea behind the STROBE LED is that is used for flash light and should not be like on/off state, but rather the (quite) short pulse.
Combining these two together may even overheat the real strobe LED if used.
That said, is that platform using strobe GPIO for the privacy LED for real?!
Signature · 2 lines
With Best Regards, Andy Shevchenko
Thank you Andy,
Quoted 9 lines · Andy Shevchenko
Quoted 2 lines · Hao Yao
Strobe pin is used for Lattice MIPI aggregator to control the LED so it can be handled together with privacy LED.
Thinking about this more, I am not now sure that this is a good approach. The idea behind the STROBE LED is that is used for flash light and should not be like on/off state, but rather the (quite) short pulse.
Combining these two together may even overheat the real strobe LED if used.
I agree. If the GPIO is used for a real flash LED, is it better to develop a new driver to control it. For example, some cameras need a flashlight device "LM3643".
Quoted 1 line
That said, is that platform using strobe GPIO for the privacy LED for real?!
On my Meteor Lake device, this pin is used for IR camera so actually it should control the IR LED. However I still don't know its detail usage. It may depends on the Lattice firmware, because I found only the handshake pin takes effects now and can't do more experiments. I think we should leave it open and I will update when I find something new.