Skip to contentSkip to conversation

nvme-pci: Fix EEH failure on ppc after subsystem reset

PATCH Superseded Nilay Shroff 1 participant 1 message Jan 31, 2024 NVMe

lore
Share & tools
lore
#0 lore raw

PATCH 1/1 nvme-pci: Fix EEH failure on ppc after subsystem reset

If the nvme subsyetm reset causes the loss of communication to the nvme adapter then EEH could potnetially recover the adapter. The detection of comminication loss to the adapter only happens when the nvme driver attempts to read an MMIO register.

The nvme subsystem reset command writes 0x4E564D65 to NSSR register and schedule adapter reset.In the case nvme subsystem reset caused the loss of communication to the nvme adapter then either IO timeout event or adapter reset handler could detect it. If IO timeout even could detect loss of communication then EEH handler is able to recover the communication to the adapter. This change was implemented in commit 651438bb0af5213 ("nvme-pci: Fix EEH failure on ppc"). However if the adapter communication loss is detected in nvme reset work handler then EEH is unable to successfully finish the adapter recovery.

This patch ensures that,
- nvme driver reset handler would observer pci channel was offline after a failed MMIO read and avoids marking the controller state to DEAD and thus gives a fair chance to EEH handler to recover the nvme adapter.

- if nvme controller is already in RESETTNG state and pci channel frozen error is detected then nvme driver pci-error-handler code sends the correct error code (PCI_ERS_RESULT_NEED_RESET) back to the EEH handler so that EEH handler could proceed with the pci slot reset.

[  131.415601] EEH: Recovering PHB#40-PE#10000
[  131.415619] EEH: PE location: N/A, PHB location: N/A
[  131.415623] EEH: Frozen PHB#40-PE#10000 detected
[  131.415627] EEH: Call Trace:
[  131.415629] EEH: [c000000000051078] __eeh_send_failure_event+0x7c/0x15c
[  131.415782] EEH: [c000000000049bdc] eeh_dev_check_failure.part.0+0x27c/0x6b0
[  131.415789] EEH: [c000000000cb665c] nvme_pci_reg_read32+0x78/0x9c
[  131.415802] EEH: [c000000000ca07f8] nvme_wait_ready+0xa8/0x18c
[  131.415814] EEH: [c000000000cb7070] nvme_dev_disable+0x368/0x40c
[  131.415823] EEH: [c000000000cb9970] nvme_reset_work+0x198/0x348
[  131.415830] EEH: [c00000000017b76c] process_one_work+0x1f0/0x4f4
[  131.415841] EEH: [c00000000017be2c] worker_thread+0x3bc/0x590
[  131.415846] EEH: [c00000000018a46c] kthread+0x138/0x140
[  131.415854] EEH: [c00000000000dd58] start_kernel_thread+0x14/0x18
[  131.415864] EEH: This PCI device has failed 1 times in the last hour
[  131.415874] EEH: Notify device drivers to shutdown
[  131.415882] EEH: Beginning: 'error_detected(IO frozen)'
[  131.415888] PCI 0040:01:00.0#10000: EEH: Invoking nvme->error_detected
[  131.415891] nvme nvme1: frozen state error detected, reset controller
[  131.515358] nvme 0040:01:00.0: enabling device (0000 -> 0002)
[  131.515778] nvme nvme1: Disabling device after reset failure: -19
[  131.555336] PCI 0040:01:00.0#10000: EEH: nvme driver reports: 'disconnect'
[  131.555343] EEH: Finished:'error_detected(IO frozen)'
[  131.555371] EEH: Unable to recover from failure from PHB#40-PE#10000.
[  131.555371] Please try reseating or replacing it
---
 drivers/nvme/host/pci.c | 16 +++++++++++++---
 1 file changed, 13 insertions(+), 3 deletions(-)
drivers/nvme/host/pci.c +13 -3
index c1d6357ec98a..a6ba46e727ba 100644
@@ -2776,6 +2776,14 @@ static void nvme_reset_work(struct work_struct *work)
  out_unlock:
 	mutex_unlock(&dev->shutdown_lock);
  out:
+	/*
+	 * If PCI recovery is ongoing then let it finish first
+	 */
+	if (pci_channel_offline(to_pci_dev(dev->dev))) {
+		dev_warn(dev->ctrl.device, "PCI recovery is ongoing so let it finish\n");
+		return;
+	}
+
 	/*
 	 * Set state to deleting now to avoid blocking nvme_wait_reset(), which
 	 * may be holding this pci_dev's device lock.
@@ -3295,9 +3303,11 @@ static pci_ers_result_t nvme_error_detected(struct pci_dev *pdev,
 	case pci_channel_io_frozen:
 		dev_warn(dev->ctrl.device,
 			"frozen state error detected, reset controller\n");
-		if (!nvme_change_ctrl_state(&dev->ctrl, NVME_CTRL_RESETTING)) {
-			nvme_dev_disable(dev, true);
-			return PCI_ERS_RESULT_DISCONNECT;
+		if (nvme_ctrl_state(&dev->ctrl) != NVME_CTRL_RESETTING) {
+			if (!nvme_change_ctrl_state(&dev->ctrl, NVME_CTRL_RESETTING)) {
+				nvme_dev_disable(dev, true);
+				return PCI_ERS_RESULT_DISCONNECT;
+			}
 		}
 		nvme_dev_disable(dev, false);
 		return PCI_ERS_RESULT_NEED_RESET;
Signature · 1 line
2.43.0