thunderbolt: Increase sideband access polling delay
Subsystems (2)
PATCH 1/2 thunderbolt: Increase sideband access polling delay
The USB4 sideband access is slow compared to the high-speed link and the access timing parameters are tens of milliseconds according the spec. To avoid too much unnecessary polling for the sideband pass the wait delay to usb4_port_wait_for_bit() and use larger (5ms) value compared to the high-speed access.
--- drivers/thunderbolt/usb4.c | 22 +++++++++++++++------- 1 file changed, 15 insertions(+), 7 deletions(-)
drivers/thunderbolt/usb4.c +15 -7
@@ -52,6 +52,10 @@ enum usb4_ba_index {#define USB4_BA_VALUE_MASK GENMASK(31, 16)#define USB4_BA_VALUE_SHIFT 16 +/* Delays in us used with usb4_port_wait_for_bit() */ +#define USB4_PORT_DELAY 50 +#define USB4_PORT_SB_DELAY 5000 + static int usb4_native_switch_op(struct tb_switch *sw, u16 opcode, u32 *metadata, u8 *status, const void *tx_data, size_t tx_dwords,
@@ -1245,7 +1249,7 @@ void usb4_port_unconfigure_xdomain(struct tb_port *port) }static int usb4_port_wait_for_bit (struct tb_port *port,u32 offset,u32 bit, -u32 value,int timeout_msec) +u32 value,int timeout_msec,unsigned long delay_usec) {ktime_t timeout =ktime_add_ms (ktime_get (), timeout_msec);
@@ -1260,7 +1264,7 @@ static int usb4_port_wait_for_bit(struct tb_port *port, u32 offset, u32 bit,if ((val & bit) == value)return 0 ; -usleep_range (50 ,100 ); +fsleep (delay_usec); }while (ktime_before (ktime_get (), timeout));return -ETIMEDOUT ;
@@ -1308,7 +1312,7 @@ static int usb4_port_sb_read(struct tb_port *port, enum usb4_sb_target target,return ret; ret =usb4_port_wait_for_bit (port, port->cap_usb4 +PORT_CS_1 , -PORT_CS_1_PND ,0 ,500 ); +PORT_CS_1_PND ,0 ,500 ,USB4_PORT_SB_DELAY );if (ret)return ret;
@@ -1355,7 +1359,7 @@ static int usb4_port_sb_write(struct tb_port *port, enum usb4_sb_target target,return ret; ret =usb4_port_wait_for_bit (port, port->cap_usb4 +PORT_CS_1 , -PORT_CS_1_PND ,0 ,500 ); +PORT_CS_1_PND ,0 ,500 ,USB4_PORT_SB_DELAY );if (ret)return ret;
@@ -1410,6 +1414,8 @@ static int usb4_port_sb_op(struct tb_port *port, enum usb4_sb_target target,if (val != opcode)return usb4_port_sb_opcode_err_to_errno (val); + +fsleep (USB4_PORT_SB_DELAY ); }while (ktime_before (ktime_get (), timeout));return -ETIMEDOUT ;
@@ -1591,13 +1597,14 @@ int usb4_port_asym_start(struct tb_port *port)* port started the symmetry transition. */ ret =usb4_port_wait_for_bit (port, port->cap_usb4 +PORT_CS_19 , -PORT_CS_19_START_ASYM ,0 ,1000 ); +PORT_CS_19_START_ASYM ,0 ,1000 , +USB4_PORT_DELAY );if (ret)return ret;/* Then wait for the transtion to be completed */ return usb4_port_wait_for_bit (port, port->cap_usb4 +PORT_CS_18 , -PORT_CS_18_TIP ,0 ,5000 ); +PORT_CS_18_TIP ,0 ,5000 ,USB4_PORT_DELAY ); }/**
@@ -2123,7 +2130,8 @@ static int usb4_usb3_port_cm_request(struct tb_port *port, bool request)*/ val &=ADP_USB3_CS_2_CMR ;return usb4_port_wait_for_bit (port, port->cap_adap +ADP_USB3_CS_1 , -ADP_USB3_CS_1_HCA , val,1500 ); +ADP_USB3_CS_1_HCA , val,1500 , +USB4_PORT_DELAY ); }static inline int usb4_usb3_port_set_cm_request (struct tb_port *port)
Signature · 1 line
2.43.0
PATCH 2/2 thunderbolt: No need to loop over all retimers if access fails
When we read the NVM authentication status or unsetting the inbound SBTX there is no point to continue the loop after first access to a retimer fails because there won't be any more retimers after this anyway so bail out from the loops early.
--- drivers/thunderbolt/retimer.c | 12 ++++++++---- 1 file changed, 8 insertions(+), 4 deletions(-)
drivers/thunderbolt/retimer.c +8 -4
@@ -199,8 +199,10 @@ static void tb_retimer_nvm_authenticate_status(struct tb_port *port, u32 *status* If the retimer has it set, store it for the new retimer * device instance. */ -for (i =1 ; i <=TB_MAX_RETIMER_INDEX ; i++) -usb4_port_retimer_nvm_authenticate_status (port, i, &status[i]); +for (i =1 ; i <=TB_MAX_RETIMER_INDEX ; i++) { +if (usb4_port_retimer_nvm_authenticate_status (port, i, &status[i])) +break ; + } }static void tb_retimer_set_inbound_sbtx (struct tb_port *port)
@@ -234,8 +236,10 @@ static void tb_retimer_unset_inbound_sbtx(struct tb_port *port)tb_port_dbg (port,"disabling sideband transactions\n" ); -for (i =TB_MAX_RETIMER_INDEX ; i >=1 ; i--) -usb4_port_retimer_unset_inbound_sbtx (port, i); +for (i =TB_MAX_RETIMER_INDEX ; i >=1 ; i--) { +if (usb4_port_retimer_unset_inbound_sbtx (port, i)) +break ; + } } static ssize_t nvm_authenticate_store(struct device *dev,
Signature · 1 line
2.43.0
Quoted 7 lines · Mika Westerberg
The USB4 sideband access is slow compared to the high-speed link and the access timing parameters are tens of milliseconds according the spec. To avoid too much unnecessary polling for the sideband pass the wait delay to
usb4_port_wait_for_bit()and use larger (5ms) value compared to the high-speed access.Signed-off-by Mika Westerberg <[email protected]>
Both patches applied to thunderbolt.git/next.