ARM: dts: stm32: add eth1 and eth2 support on stm32mp13
Subsystems (2)
PATCH 1/1 ARM: dts: stm32: add eth1 and eth2 support on stm32mp13
From: Christophe Roullier <[email protected]>
Add both ethernet MACs based on GMAC SNPS IP on stm32mp13.
---
Cc: Christophe Roullier <[email protected]>
Cc: Joe Hershberger <[email protected]>
Cc: Patrice Chotard <[email protected]>
Cc: Patrick Delaunay <[email protected]>
Cc: Ramon Fried <[email protected]>
Cc: [email protected]
Cc: [email protected]
--- arch/arm/dts/stm32mp131.dtsi | 37 ++++++++++++++++++++++++++++++++++++ arch/arm/dts/stm32mp133.dtsi | 30 +++++++++++++++++++++++++++++ 2 files changed, 67 insertions(+)
arch/arm/dts/stm32mp131.dtsi +37 -0
@@ -1328,6 +1328,37 @@ status = "disabled"; }; + eth1: eth1@5800a000 { + compatible = "snps,dwmac-4.20a", "st,stm32mp13-dwmac"; + reg = <0x5800a000 0x2000>; + reg-names = "stmmaceth"; + interrupts-extended = <&intc GIC_SPI 62 IRQ_TYPE_LEVEL_HIGH>, + <&exti 68 1>; + interrupt-names = "macirq", "eth_wake_irq"; + clock-names = "stmmaceth", + "mac-clk-tx", + "mac-clk-rx", + "ethstp", + "eth-ck"; + clocks = <&rcc ETH1MAC>, + <&rcc ETH1TX>, + <&rcc ETH1RX>, + <&rcc ETH1STP>, + <&rcc ETH1CK_K>; + st,syscon = <&syscfg 0x4 0xff0000>; + snps,mixed-burst; + snps,pbl = <2>; + snps,axi-config = <&stmmac_axi_config_1>; + snps,tso; + status = "disabled"; + + stmmac_axi_config_1: stmmac-axi-config { + snps,wr_osr_lmt = <0x7>; + snps,rd_osr_lmt = <0x7>; + snps,blen = <0 0 0 0 16 8 4>; + }; + }; + usbh_ohci: usb@5800c000 { compatible = "generic-ohci"; reg = <0x5800c000 0x1000>;
@@ -1404,6 +1435,12 @@ ts_cal2: calib@5e { reg = <0x5e 0x2>; }; + ethernet_mac1_address: mac1@e4 { + reg = <0xe4 0x6>; + }; + ethernet_mac2_address: mac2@ea { + reg = <0xea 0x6>; + }; }; /*
arch/arm/dts/stm32mp133.dtsi +30 -0
@@ -64,5 +64,35 @@ }; }; }; + + eth2: eth2@5800e000 { + compatible = "snps,dwmac-4.20a", "st,stm32mp13-dwmac"; + reg = <0x5800e000 0x2000>; + reg-names = "stmmaceth"; + interrupts-extended = <&intc GIC_SPI 97 IRQ_TYPE_LEVEL_HIGH>; + interrupt-names = "macirq"; + clock-names = "stmmaceth", + "mac-clk-tx", + "mac-clk-rx", + "ethstp", + "eth-ck"; + clocks = <&rcc ETH2MAC>, + <&rcc ETH2TX>, + <&rcc ETH2RX>, + <&rcc ETH2STP>, + <&rcc ETH2CK_K>; + st,syscon = <&syscfg 0x4 0xff000000>; + snps,mixed-burst; + snps,pbl = <2>; + snps,axi-config = <&stmmac_axi_config_2>; + snps,tso; + status = "disabled"; + + stmmac_axi_config_2: stmmac-axi-config { + snps,wr_osr_lmt = <0x7>; + snps,rd_osr_lmt = <0x7>; + snps,blen = <0 0 0 0 16 8 4>; + }; + }; }; };
Signature · 1 line
2.43.0
Quoted 103 lines · Marek Vasut
From: Christophe Roullier <[email protected]>
Add both ethernet MACs based on GMAC SNPS IP on stm32mp13.
Signed-off-by Christophe Roullier <[email protected]>---
Cc: Christophe Roullier <[email protected]>
Cc: Joe Hershberger <[email protected]>
Cc: Patrice Chotard <[email protected]>
Cc: Patrick Delaunay <[email protected]>
Cc: Ramon Fried <[email protected]>
Cc: [email protected]
Cc: [email protected]--- arch/arm/dts/stm32mp131.dtsi | 37 ++++++++++++++++++++++++++++++++++++ arch/arm/dts/stm32mp133.dtsi | 30 +++++++++++++++++++++++++++++ 2 files changed, 67 insertions(+)arch/arm/dts/stm32mp131.dtsi +37
-0@@ -1328,6 +1328,37 @@ status = "disabled"; }; + eth1: eth1@5800a000 { + compatible = "snps,dwmac-4.20a", "st,stm32mp13-dwmac"; + reg = <0x5800a000 0x2000>; + reg-names = "stmmaceth"; + interrupts-extended = <&intc GIC_SPI 62 IRQ_TYPE_LEVEL_HIGH>, + <&exti 68 1>; + interrupt-names = "macirq", "eth_wake_irq"; + clock-names = "stmmaceth", + "mac-clk-tx", + "mac-clk-rx", + "ethstp", + "eth-ck"; + clocks = <&rcc ETH1MAC>, + <&rcc ETH1TX>, + <&rcc ETH1RX>, + <&rcc ETH1STP>, + <&rcc ETH1CK_K>; + st,syscon = <&syscfg 0x4 0xff0000>; + snps,mixed-burst; + snps,pbl = <2>; + snps,axi-config = <&stmmac_axi_config_1>; + snps,tso; + status = "disabled"; + + stmmac_axi_config_1: stmmac-axi-config { + snps,wr_osr_lmt = <0x7>; + snps,rd_osr_lmt = <0x7>; + snps,blen = <0 0 0 0 16 8 4>; + }; + }; + usbh_ohci: usb@5800c000 { compatible = "generic-ohci"; reg = <0x5800c000 0x1000>;@@ -1404,6 +1435,12 @@ ts_cal2: calib@5e { reg = <0x5e 0x2>; }; + ethernet_mac1_address: mac1@e4 { + reg = <0xe4 0x6>; + }; + ethernet_mac2_address: mac2@ea { + reg = <0xea 0x6>; + }; }; /*arch/arm/dts/stm32mp133.dtsi +22
-0@@ -64,5 +64,35 @@ }; }; }; + + eth2: eth2@5800e000 { + compatible = "snps,dwmac-4.20a", "st,stm32mp13-dwmac"; + reg = <0x5800e000 0x2000>; + reg-names = "stmmaceth"; + interrupts-extended = <&intc GIC_SPI 97 IRQ_TYPE_LEVEL_HIGH>; + interrupt-names = "macirq"; + clock-names = "stmmaceth", + "mac-clk-tx", + "mac-clk-rx", + "ethstp", + "eth-ck"; + clocks = <&rcc ETH2MAC>, + <&rcc ETH2TX>, + <&rcc ETH2RX>, + <&rcc ETH2STP>, + <&rcc ETH2CK_K>; + st,syscon = <&syscfg 0x4 0xff000000>; + snps,mixed-burst; + snps,pbl = <2>; + snps,axi-config = <&stmmac_axi_config_2>; + snps,tso;
arch/arm/dts/stm32mp133.dtsi line 98
Quoted 10 lines
arch/arm/dts/stm32mp133.dtsi +8
-0+ status = "disabled"; + + stmmac_axi_config_2: stmmac-axi-config { + snps,wr_osr_lmt = <0x7>; + snps,rd_osr_lmt = <0x7>; + snps,blen = <0 0 0 0 16 8 4>; + }; + }; }; };
Thanks
Patrice