arm64: dts: rockchip: move uart2 pinmux to dtsi on rk3588-tiger
Subsystems (2)
Heiko Stuebner
maintainerPATCH v2 1/1 arm64: dts: rockchip: move uart2 pinmux to dtsi on rk3588-tiger
From: Heiko Stuebner <[email protected]>
The association of uart2 to the q7-uart pins is part of the module itself and not the baseboard used. Therefore move the pinctrl over to the tiger dtsi.
Signed-off-by Heiko Stuebner <[email protected]>
Reviewed-by Quentin Schulz <[email protected]>
---
changes in v2:
- add comment specifying where the signals go to on the Q7 connector
- add Quentin's review
arch/arm64/boot/dts/rockchip/rk3588-tiger-haikou.dts | 1 - arch/arm64/boot/dts/rockchip/rk3588-tiger.dtsi | 5 +++++ 2 files changed, 5 insertions(+), 1 deletion(-)
arch/arm64/boot/dts/rockchip/rk3588-tiger-haikou.dts +0 -1
@@ -231,7 +231,6 @@ &u2phy3_host { }; &uart2 { - pinctrl-0 = <&uart2m2_xfer>; status = "okay"; };
arch/arm64/boot/dts/rockchip/rk3588-tiger.dtsi +5 -0
@@ -688,6 +688,11 @@ &tsadc { status = "okay"; }; +/* Routed to UART0 on the Q7 connector */ +&uart2 { + pinctrl-0 = <&uart2m2_xfer>; +}; + /* Mule-ATtiny UPDI */ &uart4 { pinctrl-0 = <&uart4m2_xfer>;
Signature · 1 line
2.39.2
Quoted 8 lines · Heiko Stuebner
From: Heiko Stuebner <[email protected]>
The association of uart2 to the q7-uart pins is part of the module itself and not the baseboard used. Therefore move the pinctrl over to the tiger dtsi.
[...]
Applied, thanks!
[1/1] arm64: dts: rockchip: move uart2 pinmux to dtsi on rk3588-tiger
commit: 5adbad5c464a708a87cf5ade1bfe2ca947bb2f82
Best regards,
Signature · 1 line
Heiko Stuebner <[email protected]>