extcon: Add LC824206XA microUSB switch driver
PATCH v2 1/1 extcon: Add LC824206XA microUSB switch driver
Add a new driver for the ON Semiconductor LC824206XA microUSB switch and accessory detector chip.
ON Semiconductor has an "Advance Information" datasheet available (ENA2222-D.PDF), but no full datasheet. So there is no documentation available for the registers.
This driver is based on the register info from the extcon-fsa9285.c driver, from the Lollipop Android sources for the Lenovo Yoga Tablet 2 (Pro) 830 / 1050 / 1380 models. Note despite the name this is actually a driver for the LC824206XA not the FSA9285.
This has only been tested on a Lenovo Yoga Tablet 2 Pro 1380 and using the driver on other setups may require additional work.
So far this driver is only used on x86/ACPI (non devicetree) devs. Therefor there is no devicetree bindings documentation for this driver's "onnn,enable-miclr-for-dcp" property since this is not used in actual devicetree files and the dt bindings maintainers have requested properties with no actual dt users to _not_ be added to the dt bindings.
---
Changes in v2:
- Fix whitespace issues reported by checkpatch
--- drivers/extcon/Kconfig | 11 + drivers/extcon/Makefile | 1 + drivers/extcon/extcon-lc824206xa.c | 500 +++++++++++++++++++++++++++++ 3 files changed, 512 insertions(+) create mode 100644 drivers/extcon/extcon-lc824206xa.c
drivers/extcon/Kconfig +11 -0
@@ -75,6 +75,17 @@ config EXTCON_INTEL_MRFLD Say Y here to enable extcon support for charger detection / control on the Intel Merrifield Basin Cove PMIC. +config EXTCON_LC824206XA + tristate "LC824206XA extcon Support" + depends on I2C + depends on POWER_SUPPLY + help + Say Y here to enable support for the ON Semiconductor LC824206XA + microUSB switch and accessory detector chip. The LC824206XA is a USB + port accessory detector and switch. The LC824206XA is fully controlled + using I2C and enables USB data, stereo and mono audio, video, + microphone and UART data to use a common connector port. + config EXTCON_MAX14577 tristate "Maxim MAX14577/77836 EXTCON Support" depends on MFD_MAX14577
drivers/extcon/Makefile +1 -0
@@ -12,6 +12,7 @@ obj-$(CONFIG_EXTCON_GPIO) += extcon-gpio.o obj-$(CONFIG_EXTCON_INTEL_INT3496) += extcon-intel-int3496.o obj-$(CONFIG_EXTCON_INTEL_CHT_WC) += extcon-intel-cht-wc.o obj-$(CONFIG_EXTCON_INTEL_MRFLD) += extcon-intel-mrfld.o +obj-$(CONFIG_EXTCON_LC824206XA) += extcon-lc824206xa.o obj-$(CONFIG_EXTCON_MAX14577) += extcon-max14577.o obj-$(CONFIG_EXTCON_MAX3355) += extcon-max3355.o obj-$(CONFIG_EXTCON_MAX77693) += extcon-max77693.o
drivers/extcon/extcon-lc824206xa.c new file +500 -0
500 lines not on this page · raw message
Signature · 1 line
2.44.0