i3c: master: svc: fix IBIWON not set if IBI follow a hot join
Subsystems (3)
Frank Li
maintainerPATCH v2 1/2 i3c: master: svc: fix IBIWON not set if IBI follow a hot join
When an In-Band Interrupt(IBI) occurs after svc_i3c_master_do_daa_locked(), typically triggered during a Hot Join (HJ) event, the IBIWON flag fails to be set when issuing an auto IBI command.
The issue stems from the omission of emitting STOP upon successful execution of svc_i3c_master_do_daa_locked(). Consequently, the controller interprets it as a repeat start when emitting the auto IBI command. Per the I3C specification, an IBI should never occur during a repeat start, thus preventing the IBIWON flag from being set.
Emit STOP regardless of the success or failure of svc_i3c_master_do_daa_locked() to match I3C spec requirement.
---
Notes:
Change from v1 to v2
- update fixes tag
drivers/i3c/master/svc-i3c-master.c | 8 ++++---- 1 file changed, 4 insertions(+), 4 deletions(-)
drivers/i3c/master/svc-i3c-master.c +4 -4
@@ -961,11 +961,11 @@ static int svc_i3c_master_do_daa(struct i3c_master_controller *m)spin_lock_irqsave (&master->xferqueue.lock, flags); ret =svc_i3c_master_do_daa_locked (master, addrs, &dev_nb);spin_unlock_irqrestore (&master->xferqueue.lock, flags); -if (ret) { -svc_i3c_master_emit_stop (master); -svc_i3c_master_clear_merrwarn (master); + +svc_i3c_master_emit_stop (master); +svc_i3c_master_clear_merrwarn (master); +if (ret) goto rpm_out; - }/* Register all devices who participated to the core */ for (i =0 ; i < dev_nb; i++) {
Signature · 1 line
2.34.1
Frank Li
maintainerPATCH v2 2/2 i3c: master: svc: resend target address when get NACK
According to I3C Spec 1.1.1, 11-Jun-2021, section: 5.1.2.2.3:
If the Controller chooses to start an I3C Message with an I3C Dynamic Address, then special provisions shall be made because that same I3C Target may be initiating an IBI or a Controller Role Request. So, one of three things may happen: (skip 1, 2)
3. The Addresses match and the RnW bits also match, and so neither Controller nor Target will ACK since both are expecting the other side to provide ACK. As a result, each side might think it had "won" arbitration, but neither side would continue, as each would subsequently see that the other did not provide ACK.
...
For either value of RnW: Due to the NACK, the Controller shall defer the Private Write or Private Read, and should typically transmit the Target
^^^^^^^^^^^^^^^^^^^
Address again after a Repeated START (i.e., the next one or any one prior ^^^^^^^^^^^^^
to a STOP in the Frame). Since the Address Header following a Repeated START is not arbitrated, the Controller will always win (see Section 5.1.2.2.4).
Resend target address again if address is not 7E and controller get NACK.
---
Notes:
Change from v1 to v2
Add Reviewed-by: Miquel Raynal <[email protected]>
drivers/i3c/master/svc-i3c-master.c | 58 ++++++++++++++++++++++------- 1 file changed, 44 insertions(+), 14 deletions(-)
drivers/i3c/master/svc-i3c-master.c +44 -14
@@ -1052,29 +1052,59 @@ static int svc_i3c_master_xfer(struct svc_i3c_master *master, u8 *in, const u8 *out, unsigned int xfer_len, unsigned int *actual_len, bool continued) { + int retry = 2;u32 reg;int ret;/* clean SVC_I3C_MINT_IBIWON w1c bits */ writel (SVC_I3C_MINT_IBIWON , master->regs +SVC_I3C_MSTATUS ); -writel (SVC_I3C_MCTRL_REQUEST_START_ADDR | - xfer_type | -SVC_I3C_MCTRL_IBIRESP_NACK | -SVC_I3C_MCTRL_DIR (rnw) | -SVC_I3C_MCTRL_ADDR (addr) | -SVC_I3C_MCTRL_RDTERM (*actual_len), - master->regs +SVC_I3C_MCTRL ); - ret =readl_poll_timeout (master->regs +SVC_I3C_MSTATUS , reg, +while (retry--) { +writel (SVC_I3C_MCTRL_REQUEST_START_ADDR | + xfer_type | +SVC_I3C_MCTRL_IBIRESP_NACK | +SVC_I3C_MCTRL_DIR (rnw) | +SVC_I3C_MCTRL_ADDR (addr) | +SVC_I3C_MCTRL_RDTERM (*actual_len), + master->regs +SVC_I3C_MCTRL ); + + ret =readl_poll_timeout (master->regs +SVC_I3C_MSTATUS , reg,SVC_I3C_MSTATUS_MCTRLDONE (reg),0 ,1000 ); -if (ret) - goto emit_stop; +if (ret) + goto emit_stop; -if (readl (master->regs +SVC_I3C_MERRWARN ) &SVC_I3C_MERRWARN_NACK ) { - ret = -ENXIO ; - *actual_len =0 ; - goto emit_stop; +if (readl (master->regs +SVC_I3C_MERRWARN ) &SVC_I3C_MERRWARN_NACK ) { +/* +* According to I3C Spec 1.1.1, 11-Jun-2021, section: 5.1.2.2.3. +* If the Controller chooses to start an I3C Message with an I3C Dynamic +* Address, then special provisions shall be made because that same I3C +* Target may be initiating an IBI or a Controller Role Request. So, one of +* three things may happen: (skip 1, 2) +* +* 3. The Addresses match and the RnW bits also match, and so neither +* Controller nor Target will ACK since both are expecting the other side to +* provide ACK. As a result, each side might think it had "won" arbitration, +* but neither side would continue, as each would subsequently see that the +* other did not provide ACK. +* ... +* For either value of RnW: Due to the NACK, the Controller shall defer the +* Private Write or Private Read, and should typically transmit the Target +* Address again after a Repeated START (i.e., the next one or any one prior +* to a STOP in the Frame). Since the Address Header following a Repeated +* START is not arbitrated, the Controller will always win (see Section +* 5.1.2.2.4). +*/ +if (retry && addr !=0x7e ) { +writel (SVC_I3C_MERRWARN_NACK , master->regs +SVC_I3C_MERRWARN ); + }else { + ret = -ENXIO ; + *actual_len =0 ; + goto emit_stop; + } + }else { +break ; + } }/*
Signature · 1 line
2.34.1
Re: (subset) [PATCH v2 2/2] i3c: master: svc: resend target address when get NACK
Quoted 8 lines · Frank Li
According to I3C Spec 1.1.1, 11-Jun-2021, section: 5.1.2.2.3:
If the Controller chooses to start an I3C Message with an I3C Dynamic Address, then special provisions shall be made because that same I3C Target may be initiating an IBI or a Controller Role Request. So, one of three things may happen: (skip 1, 2)
[...]
Applied, thanks!
[2/2] i3c: master: svc: resend target address when get NACK
https://git.kernel.org/abelloni/c/2d15862dfba6
Best regards,
Signature · 3 lines
Alexandre Belloni, co-owner and COO, Bootlin Embedded Linux and Kernel engineering https://bootlin.com
Hi Frank,
[email protected] wrote on Mon, 3 Jun 2024 11:15:26 -0400:
Quoted 10 lines
When an In-Band Interrupt(IBI) occurs after
svc_i3c_master_do_daa_locked(), typically triggered during a Hot Join (HJ) event, the IBIWON flag fails to be set when issuing an auto IBI command.The issue stems from the omission of emitting STOP upon successful execution of
svc_i3c_master_do_daa_locked(). Consequently, the controller interprets it as a repeat start when emitting the auto IBI command. Per the I3C specification, an IBI should never occur during a repeat start, thus preventing the IBIWON flag from being set.
Quoted 6 lines
Emit STOP regardless of the success or failure of
svc_i3c_master_do_daa_locked()to match I3C spec requirement.Cc <[email protected]>Fixes 05b26c31a485 ("i3c: master: svc: add hot join support")Signed-off-by Frank Li <[email protected]>
Thanks,
Miquèl
Frank Li
maintainerQuoted 14 lines · Miquel Raynal
Hi Frank,
[email protected] wrote on Mon, 3 Jun 2024 11:15:26 -0400:
Quoted 10 lines
When an In-Band Interrupt(IBI) occurs after
svc_i3c_master_do_daa_locked(), typically triggered during a Hot Join (HJ) event, the IBIWON flag fails to be set when issuing an auto IBI command.The issue stems from the omission of emitting STOP upon successful execution of
svc_i3c_master_do_daa_locked(). Consequently, the controller interprets it as a repeat start when emitting the auto IBI command. Per the I3C specification, an IBI should never occur during a repeat start, thus preventing the IBIWON flag from being set.
Quoted 8 lines
Quoted 6 lines
Emit STOP regardless of the success or failure of
svc_i3c_master_do_daa_locked()to match I3C spec requirement.Cc <[email protected]>Fixes 05b26c31a485 ("i3c: master: svc: add hot join support")Signed-off-by Frank Li <[email protected]>Reviewed-by Miquel Raynal <[email protected]>
Please hold on this patch. Hardware can emit stop automatically. It need better fix. Let me work on new version for this one.
Quoted 3 lines
Thanks,
Miquèl