Skip to contentSkip to conversation

arm64: dts: ls1028a-rdb: Add EEPROM nodes to I2C bus

PATCH Applied Mike Looijmans 2 participants 2 messages Jun 4, 2024 – Jun 16, 2024 1 message not in the archive

Subsystems (2)
lore
Share & tools
lore

A message that is not in the archive (sent off-list or not yet received): 1b153bce-a66a-45ee-a5c6-963ea6fb1c82.949ef384-8293-46b8-903f-40a477c056ae.c99f8488-228d-4347-9f04-8a0b4c3c2a3f@emailsignatures365.codetwo.com

#1 lore raw

PATCH 1/1 arm64: dts: ls1028a-rdb: Add EEPROM nodes to I2C bus

The LS1028ARDB board contains three EEPROM devices, for storing boot code, DDR SPD and board information. Add the missing entries to the devicetree.

---

 .../boot/dts/freescale/fsl-ls1028a-rdb.dts    | 31 +++++++++++++++++++
 1 file changed, 31 insertions(+)
arch/arm64/boot/dts/freescale/fsl-ls1028a-rdb.dts +31 -0
index ecd2c1ea177f..757a34ba7da3 100644
@@ -201,6 +201,37 @@ i2c-mux@77 {
 		#address-cells = <1>;
 		#size-cells = <0>;
 
+		i2c@0 {
+			#address-cells = <1>;
+			#size-cells = <0>;
+			reg = <0x0>;
+
+			/* Atmel AT24C512C-XHD­B: 64 KB EEPROM */
+			eeprom@50 {
+				compatible = "atmel,24c512";
+				reg = <0x50>;
+				#address-cells = <1>;
+				#size-cells = <1>;
+			};
+
+			/* AT24C04C 512-byte DDR4 SPD EEPROM */
+			/* Documentation says 0x51, but must be even and i2cdetect says 0x52 */
+			eeprom@52 {
+				compatible = "atmel,24c04";
+				reg = <0x52>;
+				#address-cells = <1>;
+				#size-cells = <1>;
+			};
+
+			/* Atmel AT24C02C-XHM­B: 256-byte EEPROM */
+			eeprom@57 {
+				compatible = "atmel,24c02";
+				reg = <0x57>;
+				#address-cells = <1>;
+				#size-cells = <1>;
+			};
+		};
+
 		i2c@1 {
 			#address-cells = <1>;
 			#size-cells = <0>;
Signature · 18 lines
2.34.1


Met vriendelijke groet / kind regards,

Mike Looijmans
System Expert


TOPIC Embedded Products B.V.
Materiaalweg 4, 5681 RJ Best
The Netherlands

T: +31 (0) 499 33 69 69
E: [email protected]
W: www.topic.nl

Please consider the environment before printing this e-mail
Applied
#2 lore raw
Quoted 5 lines · Mike Looijmans

The LS1028ARDB board contains three EEPROM devices, for storing boot code, DDR SPD and board information. Add the missing entries to the devicetree.

Applied, thanks!