arm: dts: k3-am625-verdin: add combined binaries
PATCH 1/1 arm: dts: k3-am625-verdin: add combined binaries
From: Andrejs Cainikovs <[email protected]>
Add combined binaries for all Verdin AM62 variants. These binaries can be used to flash the U-Boot via single binary instead of few as it is done at the moment.
Signed-off-by Andrejs Cainikovs <[email protected]>
--- .../dts/k3-am625-verdin-wifi-dev-binman.dtsi | 68 +++++++++++++++++++ 1 file changed, 68 insertions(+)
arch/arm/dts/k3-am625-verdin-wifi-dev-binman.dtsi +68 -0
@@ -448,4 +448,72 @@ }; }; +&binman { + firmware-verdin-am62-gp.bin { + filename = "firmware-verdin-am62-gp.bin"; + + blob-ext@1 { + filename = "tiboot3-am62x-gp-verdin.bin"; + }; + + blob-ext@2 { + filename = "tispl.bin_unsigned"; + /* + * This value matches CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR + * from R5 SPL config. + */ + offset = <0x80000>; + }; + + blob-ext@3 { + filename = "u-boot.img_unsigned"; + offset = <(CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR * 512)>; + }; + }; + + firmware-verdin-am62-hs.bin { + filename = "firmware-verdin-am62-hs.bin"; + + blob-ext@1 { + filename = "tiboot3-am62x-hs-verdin.bin"; + }; + + blob-ext@2 { + filename = "tispl.bin"; + /* + * This value matches CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR + * from R5 SPL config. + */ + offset = <0x80000>; + }; + + blob-ext@3 { + filename = "u-boot.img"; + offset = <(CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR * 512)>; + }; + }; + + firmware-verdin-am62-hs-fs.bin { + filename = "firmware-verdin-am62-hs-fs.bin"; + + blob-ext@1 { + filename = "tiboot3-am62x-hs-fs-verdin.bin"; + }; + + blob-ext@2 { + filename = "tispl.bin"; + /* + * This value matches CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR + * from R5 SPL config. + */ + offset = <0x80000>; + }; + + blob-ext@3 { + filename = "u-boot.img"; + offset = <(CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR * 512)>; + }; + }; +}; + #endif /* CONFIG_TARGET_VERDIN_AM62_A53 */
Signature · 1 line
2.34.1
Quoted 5 lines · Andrejs Cainikovs
Add combined binaries for all Verdin AM62 variants. These binaries can be used to flash the U-Boot via single binary instead of few as it is done at the moment.
Applied to u-boot/next, thanks!
Signature · 1 line
Tom