doc: board: phytec: phycore-am6: Describe UART based boot
PATCH 1/1 doc: board: phytec: phycore-am6: Describe UART based boot
Describe how to boot via UART.
Signed-off-by Wadim Egorov <[email protected]>
---
For next
--- doc/board/phytec/phycore-am62x.rst | 17 +++++++++++++++++ doc/board/phytec/phycore-am64x.rst | 19 +++++++++++++++++++ 2 files changed, 36 insertions(+)
doc/board/phytec/phycore-am62x.rst +17 -0
@@ -118,6 +118,23 @@ tiboot3.bin, tispl.bin and u-boot.img are stored on the uSD card. fatload mmc 1 ${loadaddr} u-boot.img mtd write ospi.u-boot ${loadaddr} 0 ${filesize} +UART based boot +--------------- + +To boot the board via UART, set the switches to UART mode and connect to the +micro USB port labeled as "Debug UART". After power-on the build artifacts +needs to be uploaded one by one with a tool like sz. + +Example bash script sequence for running on a Linux host PC feeding all boot +artifacts needed to the device. Assuming the host uses /dev/ttyUSB0 as +the main domain serial port: + +.. prompt:: bash $ + + stty -F /dev/ttyUSB0 115200 + sb --xmodem tiboot3.bin > /dev/ttyUSB0 < /dev/ttyUSB0 + sb --ymodem tispl.bin > /dev/ttyUSB0 < /dev/ttyUSB0 + sb --ymodem u-boot.img > /dev/ttyUSB0 < /dev/ttyUSB0 Boot Modes ----------
doc/board/phytec/phycore-am64x.rst +19 -0
@@ -119,6 +119,25 @@ tiboot3.bin, tispl.bin and u-boot.img are stored on the uSD card. fatload mmc 1 ${loadaddr} u-boot.img mtd write ospi.u-boot ${loadaddr} 0 ${filesize} +UART based boot +--------------- + +To boot the board via UART, set the switches to UART mode and connect to the +micro USB port labeled as "Debug UART". After power-on the build artifacts +needs to be uploaded one by one with a tool like sz. + +Example bash script sequence for running on a Linux host PC feeding all boot +artifacts needed to the device. Assuming the host uses /dev/ttyUSB0 as +the main domain serial port: + +.. prompt:: bash $ + + stty -F /dev/ttyUSB0 115200 + sb --xmodem tiboot3.bin > /dev/ttyUSB0 < /dev/ttyUSB0 + # Resend tiboot3.bin a 2nd time due to ErrataID:i2331 + sb --xmodem tiboot3.bin > /dev/ttyUSB0 < /dev/ttyUSB0 + sb --ymodem tispl.bin > /dev/ttyUSB0 < /dev/ttyUSB0 + sb --ymodem u-boot.img > /dev/ttyUSB0 < /dev/ttyUSB0 Boot Modes ----------
Signature · 1 line
2.34.1
Quoted 3 lines · Wadim Egorov
Describe how to boot via UART.
Signed-off-by Wadim Egorov <[email protected]>
Applied to u-boot/master, thanks!
Signature · 1 line
Tom