board: gateworks: venice: Simplify Ethernet initialization
PATCH 1/1 board: gateworks: venice: Simplify Ethernet initialization
With DM enabled, there is no need for board code to initialize the Ethernet interfaces.
Specifically board_interface_eth_init will handle the configuration of GPR1.
Signed-off-by Tim Harvey <[email protected]>
--- board/gateworks/venice/venice.c | 19 ------------------- 1 file changed, 19 deletions(-)
board/gateworks/venice/venice.c +0 -19
@@ -45,22 +45,6 @@ int board_fit_config_name_match(const char *path)return -1 ; } -static int __maybe_unused setup_fec (void ) -{ -struct iomuxc_gpr_base_regs *gpr = - (struct iomuxc_gpr_base_regs *)IOMUXC_GPR_BASE_ADDR ; - -#ifndef CONFIG_IMX8MP -/* Use 125M anatop REF_CLK1 for ENET1, not from external */ -clrsetbits_le32 (&gpr->gpr[1 ],0x2000 ,0 ); -#else -/* Enable RGMII TX clk output */ -setbits_le32 (&gpr->gpr[1 ],BIT (22 )); -#endif - -return 0 ; -} -#if (IS_ENABLED (CONFIG_NET ))int board_phy_config (struct phy_device *phydev) {
@@ -91,9 +75,6 @@ int board_init(void) {venice_eeprom_init (1 ); -if (IS_ENABLED (CONFIG_FEC_MXC )) -setup_fec (); -return 0 ; }
Signature · 1 line
2.25.1