phy: marvell: phy-mvebu-cp110-comphy: improve eth_port1 on comphy4
PATCH 1/1 phy: marvell: phy-mvebu-cp110-comphy: improve eth_port1 on comphy4
According to the CN9100_MPP_information document, CP_SRD4 (comphy 4) supports 2500 BASE-X and 5000 BASE-R for ETH_PORT1. I was able to test that 2500 BASE-X is indeed supported. Unfortunately, our HW does not support 5000 BASE-R, but I assume from the document that it does, so I set the muxing there too to 0x1.
--- drivers/phy/marvell/phy-mvebu-cp110-comphy.c | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-)
drivers/phy/marvell/phy-mvebu-cp110-comphy.c +2 -2
@@ -244,8 +244,8 @@ static const struct mvebu_comphy_conf mvebu_comphy_cp110_modes[] = {GEN_CONF (4 ,1 ,PHY_MODE_USB_HOST_SS ,COMPHY_FW_MODE_USB3H ),GEN_CONF (4 ,1 ,PHY_MODE_PCIE ,COMPHY_FW_MODE_PCIE ),ETH_CONF (4 ,1 ,PHY_INTERFACE_MODE_SGMII ,0x1 ,COMPHY_FW_MODE_SGMII ), -ETH_CONF (4 ,1 ,PHY_INTERFACE_MODE_2500BASEX ,-1 ,COMPHY_FW_MODE_2500BASEX ), -ETH_CONF (4 ,1 ,PHY_INTERFACE_MODE_5GBASER ,-1 ,COMPHY_FW_MODE_XFI ), +ETH_CONF (4 ,1 ,PHY_INTERFACE_MODE_2500BASEX ,0x1 ,COMPHY_FW_MODE_2500BASEX ), +ETH_CONF (4 ,1 ,PHY_INTERFACE_MODE_5GBASER ,0x1 ,COMPHY_FW_MODE_XFI ),ETH_CONF (4 ,1 ,PHY_INTERFACE_MODE_10GBASER ,-1 ,COMPHY_FW_MODE_XFI ),/* lane 5 */ ETH_CONF(5, 1, PHY_INTERFACE_MODE_RXAUI, 0x2, COMPHY_FW_MODE_RXAUI),
Signature · 1 line
2.43.0
Quoted 8 lines · Stefan Eichenberger
According to the
CN9100_MPP_informationdocument,CP_SRD4(comphy 4) supports 2500 BASE-X and 5000 BASE-R forETH_PORT1. I was able to test that 2500 BASE-X is indeed supported. Unfortunately, our HW does not support 5000 BASE-R, but I assume from the document that it does, so I set the muxing there too to0x1.[...]
Applied, thanks!
[1/1] phy: marvell: phy-mvebu-cp110-comphy: improve eth_port1 on comphy4
commit: 8c9f085ae3384c5dfc0bc5f2f785b7adbf7d756b
Best regards,
Signature · 1 line
Vinod Koul <[email protected]>