disk: add TegraPT support
cover disk: add TegraPT support
Production Tegra20/30/114/124/132 devices use Nvidia's own partition table, which makes them a bit complicated to deal with. Luckily, it is compatible with the existing EFI partition already available in U-Boot, apart from the fact that it cannot pass Protective MBR check.
In order to address this without unwanted code additions, I have come up with this solution.
Svyatoslav Ryhel (1):
disk: add TegraPT support
disk/Kconfig | 8 ++++++++ disk/part_efi.c | 13 +++++++++++++ 2 files changed, 21 insertions(+)
Signature · 1 line
2.43.0
PATCH 1/1 disk: add TegraPT support
TegraPT is compatible with EFI part but it can't pass Protective MBR check. Skip this check if CONFIG_TEGRA_PARTITION is enabled, storage uclass is MMC and devnum is 0. Note, eMMC on supported devices MUST be aliased to mmc0.
Signed-off-by Svyatoslav Ryhel <[email protected]>
--- disk/Kconfig | 8 ++++++++ disk/part_efi.c | 13 +++++++++++++ 2 files changed, 21 insertions(+)
disk/Kconfig +8 -0
@@ -49,6 +49,14 @@ config SPL_MAC_PARTITION default y if MAC_PARTITION select SPL_PARTITIONS +config TEGRA_PARTITION + bool "Enable Nvidia Tegra partition table" + select PARTITIONS + select EFI_PARTITION + help + Say Y here if you would like to use U-Boot on a device with + Nvidia Tegra partition table. + config DOS_PARTITION bool "Enable MS Dos partition table" default y if BOOT_DEFAULTS
disk/part_efi.c +13 -0
@@ -318,6 +318,19 @@ static int part_test_efi(struct blk_desc *desc)/* Read legacy MBR from block 0 and validate it */ if ((blk_dread (desc,0 ,1 , (ulong *)legacymbr) !=1 ) || (is_pmbr_valid (legacymbr) !=1 )) { + +/* +* TegraPT is compatible with EFI part but it +* cannot pass Protective MBR check. Skip it +* if CONFIG_TEGRA_PARTITION is enabled and +* device is question is eMMC. +*/ +if (IS_ENABLED (CONFIG_TEGRA_PARTITION )) +if (!is_pmbr_valid (legacymbr) && + desc->uclass_id ==UCLASS_MMC && + !desc->devnum) +return 0 ; +return -1 ; }return 0 ;
Signature · 1 line
2.43.0