arm64: dts: qcom: x1e80100-yoga: Update panel bindings

From: Rob Clark <[email protected]>

Use the correct panel compatible, and wire up enable-gpio. It is wired up in the same way as the x1e80100-crd.

Signed-off-by Rob Clark <[email protected]>

Reviewed-by Abel Vesa <[email protected]>

---
Corresponding schema update is in drm-misc-fixes

[1/2] dt-bindings: display: panel: samsung,atna45dc02: Document ATNA45DC02

      commit: 1c4a057d01f4432704c4dc8842b6e888a91d95df

 .../dts/qcom/x1e80100-lenovo-yoga-slim7x.dts    | 17 +++++++++++++++--
 1 file changed, 15 insertions(+), 2 deletions(-)

arch/arm64/boot/dts/qcom/x1e80100-lenovo-yoga-slim7x.dts +15 -2

index 70977e9fa266..3c13331a9ef4 100644
@@ -190,7 +190,6 @@ vreg_edp_3p3: regulator-edp-3p3 {
 		pinctrl-0 = <&edp_reg_en>;
 		pinctrl-names = "default";
 
-		regulator-always-on;
 		regulator-boot-on;
 	};
 

@@ -592,9 +591,13 @@ &mdss_dp3 {
 
 	aux-bus {
 		panel {
-			compatible = "edp-panel";
+			compatible = "samsung,atna45dc02", "samsung,atna33xc20";
+			enable-gpios = <&pmc8380_3_gpios 4 GPIO_ACTIVE_HIGH>;
 			power-supply = <&vreg_edp_3p3>;
 
+			pinctrl-0 = <&edp_bl_en>;
+			pinctrl-names = "default";
+
 			port {
 				edp_panel_in: endpoint {
 					remote-endpoint = <&mdss_dp3_out>;

@@ -669,6 +672,16 @@ &pcie6a_phy {
 	status = "okay";
 };
 
+&pmc8380_3_gpios {
+	edp_bl_en: edp-bl-en-state {
+		pins = "gpio4";
+		function = "normal";
+		power-source = <0>;
+		input-disable;
+		output-enable;
+	};
+};
+
 &qupv3_0 {
 	status = "okay";
 };

Signature · 1 line

2.45.2

Use the correct panel compatible, and wire up enable-gpio. It is wired up in the same way as the x1e80100-crd.