dts: rockchip: add USB-C support to OK3588-C
Subsystems (2)
cover dts: rockchip: add USB-C support to OK3588-C
This series adds support for USB-C ports (labeled as TypeC0 and TypeC1) found on Forlinx OK3588-C board. The changes are split into two commits for better readability.
Dmitry Yashin (2):
arm64: dts: rockchip: add USB-C port 0 to OK3588-C
arm64: dts: rockchip: add USB-C port 1 to OK3588-C
.../boot/dts/rockchip/rk3588-ok3588-c.dts | 217 ++++++++++++++++++ 1 file changed, 217 insertions(+)
base-commit: e8054c08dada20f1bfb4d41a7f3902ae053d4499
Signature · 1 line
2.39.2
PATCH 1/2 arm64: dts: rockchip: add USB-C port 0 to OK3588-C
Add support for TypeC0 found on Forlinx OK3588-C. Powering the board using this port is not supported, so set power-role to source.
--- .../boot/dts/rockchip/rk3588-ok3588-c.dts | 110 ++++++++++++++++++ 1 file changed, 110 insertions(+)
arch/arm64/boot/dts/rockchip/rk3588-ok3588-c.dts +110 -0
@@ -1,6 +1,7 @@ // SPDX-License-Identifier: (GPL-2.0+ OR MIT) /dts-v1/; +#include <dt-bindings/usb/pd.h> #include "rk3588-fet3588-c.dtsi" / {
@@ -100,6 +101,18 @@ masterdai: simple-audio-card,codec { }; }; + vbus5v0_typec0: vbus5v0-typec0-regulator { + compatible = "regulator-fixed"; + regulator-name = "vbus5v0_typec0"; + enable-active-high; + gpio = <&gpio0 RK_PD0 GPIO_ACTIVE_HIGH>; + pinctrl-names = "default"; + pinctrl-0 = <&typec5v_0_pwren>; + regulator-min-microvolt = <5000000>; + regulator-max-microvolt = <5000000>; + vin-supply = <&vcc5v0_sys>; + }; + vcc12v_dcin: vcc12v-dcin-regulator { compatible = "regulator-fixed"; regulator-name = "vcc12v_dcin";
@@ -206,6 +219,51 @@ &gpu { &i2c2 { status = "okay"; + usbc0: usb-typec@22 { + compatible = "fcs,fusb302"; + reg = <0x22>; + interrupt-parent = <&gpio1>; + interrupts = <RK_PB0 IRQ_TYPE_LEVEL_LOW>; + pinctrl-names = "default"; + pinctrl-0 = <&usbc0_int>; + vbus-supply = <&vbus5v0_typec0>; + + usb_con0: connector { + compatible = "usb-c-connector"; + label = "USB-C"; + data-role = "dual"; + power-role = "source"; + source-pdos = + <PDO_FIXED(5000, 2000, PDO_FIXED_USB_COMM)>; + + ports { + #address-cells = <1>; + #size-cells = <0>; + + port@0 { + reg = <0>; + usbc0_hs: endpoint { + remote-endpoint = <&usb_host0_xhci_drd_sw>; + }; + }; + + port@1 { + reg = <1>; + usbc0_ss: endpoint { + remote-endpoint = <&usbdp_phy0_typec_ss>; + }; + }; + + port@2 { + reg = <2>; + usbc0_sbu: endpoint { + remote-endpoint = <&usbdp_phy0_typec_sbu>; + }; + }; + }; + }; + }; + tca6424a: gpio@23 { compatible = "ti,tca6424"; reg = <0x23>;
@@ -349,6 +407,16 @@ tca6424a_int: tca6424a-int { rockchip,pins = <1 RK_PA4 RK_FUNC_GPIO &pcfg_pull_up>; }; }; + + usb-typec { + typec5v_0_pwren: typec5v-0-pwren { + rockchip,pins = <0 RK_PD0 RK_FUNC_GPIO &pcfg_pull_none>; + }; + + usbc0_int: usbc0-int { + rockchip,pins = <1 RK_PB0 RK_FUNC_GPIO &pcfg_pull_up>; + }; + }; }; &pwm2 {
@@ -378,6 +446,14 @@ &tsadc { status = "okay"; }; +&u2phy0 { + status = "okay"; +}; + +&u2phy0_otg { + status = "okay"; +}; + &u2phy2 { status = "okay"; };
@@ -394,6 +470,29 @@ &u2phy3_host { status = "okay"; }; +&usbdp_phy0 { + mode-switch; + orientation-switch; + sbu1-dc-gpios = <&gpio4 RK_PA0 GPIO_ACTIVE_HIGH>; + sbu2-dc-gpios = <&gpio4 RK_PB0 GPIO_ACTIVE_HIGH>; + status = "okay"; + + port { + #address-cells = <1>; + #size-cells = <0>; + + usbdp_phy0_typec_ss: endpoint@0 { + reg = <0>; + remote-endpoint = <&usbc0_ss>; + }; + + usbdp_phy0_typec_sbu: endpoint@1 { + reg = <1>; + remote-endpoint = <&usbc0_sbu>; + }; + }; +}; + &usb_host0_ehci { status = "okay"; };
@@ -402,6 +501,17 @@ &usb_host0_ohci { status = "okay"; }; +&usb_host0_xhci { + usb-role-switch; + status = "okay"; + + port { + usb_host0_xhci_drd_sw: endpoint { + remote-endpoint = <&usbc0_hs>; + }; + }; +}; + &usb_host1_ehci { status = "okay"; };
Signature · 1 line
2.39.2
PATCH 2/2 arm64: dts: rockchip: add USB-C port 1 to OK3588-C
In reply to Dmitry YashinAdd support for TypeC1 found on Forlinx OK3588-C. Powering the board using this port is not supported, so set power-role to source.
--- .../boot/dts/rockchip/rk3588-ok3588-c.dts | 107 ++++++++++++++++++ 1 file changed, 107 insertions(+)
arch/arm64/boot/dts/rockchip/rk3588-ok3588-c.dts +107 -0
@@ -113,6 +113,18 @@ vbus5v0_typec0: vbus5v0-typec0-regulator { vin-supply = <&vcc5v0_sys>; }; + vbus5v0_typec1: vbus5v0-typec1-regulator { + compatible = "regulator-fixed"; + regulator-name = "vbus5v0_typec1"; + enable-active-high; + gpio = <&gpio0 RK_PD3 GPIO_ACTIVE_HIGH>; + pinctrl-names = "default"; + pinctrl-0 = <&typec5v_1_pwren>; + regulator-min-microvolt = <5000000>; + regulator-max-microvolt = <5000000>; + vin-supply = <&vcc5v0_sys>; + }; + vcc12v_dcin: vcc12v-dcin-regulator { compatible = "regulator-fixed"; regulator-name = "vcc12v_dcin";
@@ -286,6 +298,51 @@ &i2c5 { pinctrl-names = "default"; pinctrl-0 = <&i2c5m2_xfer>; + usbc1: usb-typec@22 { + compatible = "fcs,fusb302"; + reg = <0x22>; + interrupt-parent = <&gpio1>; + interrupts = <RK_PB3 IRQ_TYPE_LEVEL_LOW>; + pinctrl-names = "default"; + pinctrl-0 = <&usbc1_int>; + vbus-supply = <&vbus5v0_typec1>; + + usb_con1: connector { + compatible = "usb-c-connector"; + label = "USB-C"; + data-role = "dual"; + power-role = "source"; + source-pdos = + <PDO_FIXED(5000, 2000, PDO_FIXED_USB_COMM)>; + + ports { + #address-cells = <1>; + #size-cells = <0>; + + port@0 { + reg = <0>; + usbc1_hs: endpoint { + remote-endpoint = <&usb_host1_xhci_drd_sw>; + }; + }; + + port@1 { + reg = <1>; + usbc1_ss: endpoint { + remote-endpoint = <&usbdp_phy1_typec_ss>; + }; + }; + + port@2 { + reg = <2>; + usbc1_sbu: endpoint { + remote-endpoint = <&usbdp_phy1_typec_sbu>; + }; + }; + }; + }; + }; + pcf8563: rtc@51 { compatible = "nxp,pcf8563"; reg = <0x51>;
@@ -413,9 +470,17 @@ typec5v_0_pwren: typec5v-0-pwren { rockchip,pins = <0 RK_PD0 RK_FUNC_GPIO &pcfg_pull_none>; }; + typec5v_1_pwren: typec5v-1-pwren { + rockchip,pins = <0 RK_PD3 RK_FUNC_GPIO &pcfg_pull_none>; + }; + usbc0_int: usbc0-int { rockchip,pins = <1 RK_PB0 RK_FUNC_GPIO &pcfg_pull_up>; }; + + usbc1_int: usbc1-int { + rockchip,pins = <1 RK_PB3 RK_FUNC_GPIO &pcfg_pull_up>; + }; }; };
@@ -454,6 +519,14 @@ &u2phy0_otg { status = "okay"; }; +&u2phy1 { + status = "okay"; +}; + +&u2phy1_otg { + status = "okay"; +}; + &u2phy2 { status = "okay"; };
@@ -493,6 +566,29 @@ usbdp_phy0_typec_sbu: endpoint@1 { }; }; +&usbdp_phy1 { + mode-switch; + orientation-switch; + sbu1-dc-gpios = <&gpio4 RK_PA1 GPIO_ACTIVE_HIGH>; + sbu2-dc-gpios = <&gpio4 RK_PA2 GPIO_ACTIVE_HIGH>; + status = "okay"; + + port { + #address-cells = <1>; + #size-cells = <0>; + + usbdp_phy1_typec_ss: endpoint@0 { + reg = <0>; + remote-endpoint = <&usbc1_ss>; + }; + + usbdp_phy1_typec_sbu: endpoint@1 { + reg = <1>; + remote-endpoint = <&usbc1_sbu>; + }; + }; +}; + &usb_host0_ehci { status = "okay"; };
@@ -519,3 +615,14 @@ &usb_host1_ehci { &usb_host1_ohci { status = "okay"; }; + +&usb_host1_xhci { + usb-role-switch; + status = "okay"; + + port { + usb_host1_xhci_drd_sw: endpoint { + remote-endpoint = <&usbc1_hs>; + }; + }; +};
Signature · 1 line
2.39.2